Specifications

Page 19
Multi Coil Inductive
1. Mitsu 6-cyl coil pack
6-cyl wasted spark
P/N: M 6-D846251
$235.04
2. 4-cyl coil pack
w/integral ignitors
(ECU controlled only)
P/N: M 4-2100
$150.00
2
1
MoTeC Ignition Expander MoTeC Traction Control Multiplexer
MoTeC Mitsubishi Diff Controller
1. Mitsubishi Diff Controller
P/N: M MDC
$1,843.00
The Mitsubishi Diff Controller (MDC) is a direct replacement for
the Active Centre Diff (ACD) controller for the EVO 7, 8
and 9 models. The MDC is a fully programmable centre diff
controller. Six different diff control mode are selectable from
the standard ACD button located on the dash board. The modes
include 0% and 100% lock and four user programmable
modes. The MDC can be used on vehicles fitted with Active Yaw
Control (AYC) but the AYC will be disabled.
The MoTeC Ignition Expander enhances the ignition control capability
of any MoTeC ECU . The MoTeC IEX will allow a single MoTeC ECU
output to control up to 8 individual coil drivers.
P/N: M IGN EX
$412.00
Modified for use w/Autosport Connector
$779.66
Modified for use w/Denso 580
$437.00
Ignition Expander 10 foot Unterminated Harness
P/N: M IGN EX H 10
$148.15
IGN EX / TC MUX Harness Spares
18-way plug set for M IGN EX and
M TC MUX
P/N: M ECONO 18
$42.00
Did You Know?
The MoTeC ECU software will not let you perform an ignition test
while using the ignition expander. However you can easily make a
jumper and change the ignition setup in the software to 1 coil. Then
you can go into the ignition test screen, and use the jumper on the
harness at the Expander connector (Expander unplugged) and test
each coil Output
The MoTeC Traction Control Multiplexer goes
between the ECU and the wheel speed sensors It
gathers the speed information from the 4 wheels
and calculates the ground speed from the fastest
rolling wheel and speed difference from the
driven wheels. The MoTeC Traction
Control Multiplexer is very useful in
allowing 4 separate speed channels to be
brought into one input of the ECU
P/N: M TC MUX
$412.00