Specifications

Engine Management and Data Acquisition SystemsPage 14
IGN EX / TC MUX Harness Spares MoTeC Traction Control Multiplexer
Did You Know?
e MoTeC ECU software will not let you perform an ignition test while using the
ignition expander. However you can easily make a jumper and change the ignition setup
in the software to 1 coil. en you can go into the ignition test screen, and use the
jumper on the harness at the Expander connector (Expander unplugged) and test each
coil Output.
MoTeC Traction Control Multiplexer
e MoTeC Traction Control Multiplexer goes between the ECU and the wheel
speed sensors It gathers the speed information
from the 4 wheels and calculates the ground
speed from the fastest rolling wheel and speed
difference from the driven wheels. e MoTeC
Traction Control Multiplexer is very
useful in allowing 4 separate speed
channels to be brought into one input
of the ECU
MoTeC Ignition Expander
e MoTeC Ignition Expander enhances the ignition control capability of
any MoTeC ECU . e MoTeC IEX will
allow a single MoTeC ECU output to
control up to 8 individual coil drivers.
e Mitsubishi Diff Controller (MDC) is a direct replacement for the Active Centre Diff (ACD)
controller for the EVO 7, 8 and 9 models. e MDC is a fully programmable centre diff control-
ler. Six different diff control mode are selectable from the standard ACD button located on the
dash board. e modes include 0% and 100% lock and four user programmable modes. e
MDC can be used on vehicles fitted with Active Yaw Control (AYC) but the AYC will be disabled.
MoTeC Mitsubishi Diff Controller
M ECONO 18
18-way plug set for M IGN EX and M TC MUX
M TC MUX
M IGN EX
M MDC
Mitsubishi Diff Controller