Specifications

Phone [phone] • Fax [phone] • www.motec.com Page 23
Why Do I need an Ignitor - what do they do?
An ignitor is an amplifier that converts a low current signal into a high current signal. In this case the coil trigger signal coming from the ECU is low current. e
ignitor uses this low current signal to trigger the coil itself which requires high current.
Why doesnt the MoTeC have a built in ignitor?
Since the part that actually triggers the coils ia a high current device, it gets extremely hot during normal operation. at heat when placed in close proximity to the
sophisticated microprocessor controlling your engine can cause it to degrade over time. Also, should the ignitor ever fail - it can be easily accessed for replacement
- no need to send the ECU in for repair. Lastly, without the constraints of a built in ignitor MoTeC gives you the freedom to trigger any type of ignition system mak-
ing integration with your existing hardware as seamless as possible.
1. M 0227 124 D
Bosch 1-channel ignitor
2. M 0227 200
Bosch 2-channel ignitor
3. M 0227 203
Bosch 3-channel ignitor
4. M 0227 211
Bosch 4-channel ignitor
Multi-Channel Ignitors
1
2
3
4