Specifications
Table Of Contents
- MoTeC Systems West
- MoTeC Systems East
- MoTeC Steering Wheels
- Driver Displays and Loggers
- Driver Display & Logger Options/Upgrades
- Driver Displays and Loggers con’d
- Driver Displays and Loggers con’d
- Professional Lambda Meter Accessories
- Professional Lambda Meter
- MoTeC Mini Display Dash
- Expansion Boxes
- MoTeC ECU’s
- MoTeC ECU Comparison Chart
- MoTeC M800 Plug & Play ECU (OEM)
- MoTeC Beacon Transmitter and Receiver
- MoTeC ADL Hardware
- Video
- GPS Receivers
- Capacitive-Discharge Ignitions
- Capacitive-Discharge Ignitions Accessories
- Power Supply
- MoTeC Hardware
- Engine Hardware
- Sensors
- Controls
- MoTeC Sensors
- Sensors
- MoTeC ECU Sensors
- Plug-and-Play Basic or Custom-Made
- MoTeC ADL2 Hardware
- ADL / ADL2 / SD Harnesses
- MoTeC ADL Hardware
- MoTeC Wiring
- Wiring and Related
- Diagnosis and Testing
- Autosport Connectors
- Apparrel
- MoTeC Support
- MoTeC Glossary
M PDM15 M PDM30 M PDM16 M PDM32
Outputs
Number of 20 Amp Outputs 8 8 8 8
Number of 8 Amp Outputs 7 22 8 24
Inputs
Number of Inputs 16 16 12 23
Engine Management and Data Acquisition SystemsPage 24
M P155-CGO-14
Electronic Sending Unit For Fuel, Oil,
and Potable Water
Fluid level sensor.
Length = 14-inches.
Output Voltage = 0-5 volts.
Fluid Level Sensor
M DHB
Dual Half Bridge
Dual Half Bridge (DHB)
e Dual Half Bridge (DHB) is a high current amplifier which allows low current aux-
iliary outputs to drive high current loads such as motors. It contains two high current
half bridge outputs enabling it to drive a single motor in two directions, or drive two
motors in a single direction. It is also capable of high speed PWM, which can be used
for speed control of motors and for other purposes.
e DHB connects to any auxiliary output of a MoTeC ECU or Dash Logger, which
performs the control function, such as PWM speed control, direction control or servo
control.
e fully sealed case makes the DHB suitable for under bonnet mounting.
Application Examples
• Servo motor e.g. active wing control, boat trim control, inlet runner length
control, variable valve lift.
• Motor speed control e.g. electric water pump, thermo fan, fuel pump.
• Solenoid control.
Compatible with
• All MoTeC ECUs
• All MoTeC Dash Loggers
PDM32
PDM16
PDM30
PDM15
Power Distribution Modules
MoTeC PDMs are designed to replace conventional relays, fuses and circuit breakers by provid-
ing electronically switched power to the various electronical systems in the vehicle, including
motors, lights, solenoids and electronic devices such as ECUs and data systems. It also provides
full diagnostic information, including output currents and voltages, and error status that can be
monitored on a PC or transmitted via CAN to a display or logging device. Each output is over-
current, short circuit and thermal overload protected. Outputs are programmable in 1 Amp steps
and controllable via a combination of switch inputs, CAN messages and logic functions.
Power Supply