Manual

22 Sea-Doo 2010 Installation
• Now plug in the Adaptor Loom –
first, Plug B into the stock wiring
harness, then Plug A.
• Next plug the M400 ECU into the Adaptor Loom.
•
Ensure that all supplied devices are connected: M400, STC
IGN4, Relay.
These devices can all be secured by zip
Warning –
the M400 ECU MUST have
firmware version 3.52P or later loaded
BEFORE this Adaptor Loom is powered
up. If you have not loade
d the firmware you
should unplug the IGN4 device and remove
all three of the injector/ignition fuses ( #7, 8,
and 9) from Fuse Box 1, and THEN load the
3.52P firmware.
Warning –
the M400 ECU should have the
relevant start file installed before the IGN4
dev
ice and Injector/Ignition fuses are re
installed.
MoTeC
first, Plug B into the stock wiring
Ensure that all supplied devices are connected: M400, STC
-SX,
These devices can all be secured by zip
-ties.
the M400 ECU MUST have
firmware version 3.52P or later loaded
BEFORE this Adaptor Loom is powered
d the firmware you
should unplug the IGN4 device and remove
all three of the injector/ignition fuses ( #7, 8,
and 9) from Fuse Box 1, and THEN load the
the M400 ECU should have the
relevant start file installed before the IGN4
ice and Injector/Ignition fuses are re
-