Manual

24 Sea-Doo 2010 Installation
PWC Operational Differences
The PWC Plug-
In ECU closely mimics the standard OEM operation. However,
MoTeC would like to draw your attention to some operational differences
when a PWC Plug-In ECU is installed.
ECU Operation
The M400 Marine ECU engine control functionality is
less complex than
standard factory ECU;
only one mode is supported. The handlebar Mode
switching does not operate as in the stock craft.
STC-SX Device
This craft depends heavily upon CAN bus communication for correct
operation. Both the Instrument Cluster and Brake System (see below) use
CAN data for critical decisions. The M400 ECU
transmits and receives
relevant data via the STC-SX device using Custom
Data Set 1.
account should this table be changed
as Brake System or Instrument
Cluster malfunction may result.
If for any reason these systems do not operate correctly, the configuration file
and the STC-SX device should be checked first.
iBR Brake System Operation
The i
BR system works in conjunction with the Brake Lever, ECU and
Instrument Cluster to determine how the brake will operate. The interaction is
complex and not user-adjustable. On no account should
Custom Data Set
1 be changed as Brake system malfunction may result.
If for any reason the i
BR unit is not satisfied with data received from the othe
components, the Instrument Cluster will illuminate the red IBR warning light
and the brake system will no longer operate.
In this situation the craft
must be shut down and restarted before the
IBR system will be fully functional: Remove the Lanyard, wait 10
seconds, then re-install the Lanyard and re-
start the engine.
Instrument Cluster Operation
The M400 Marine ECU will control the Sea-Doo Ins
trument cluster and mimic
the original factory dash operation.
The ECU controls the dash via the STC-SX (Serial
to CAN) data adaptor; the
STC-SX receives CAN messages from the ECU, and then
re
messages to the instrument cluster.
MoTeC
In ECU closely mimics the standard OEM operation. However,
MoTeC would like to draw your attention to some operational differences
less complex than
the
only one mode is supported. The handlebar Mode
This craft depends heavily upon CAN bus communication for correct
operation. Both the Instrument Cluster and Brake System (see below) use
transmits and receives
Data Set 1.
On no
as Brake System or Instrument
If for any reason these systems do not operate correctly, the configuration file
BR system works in conjunction with the Brake Lever, ECU and
Instrument Cluster to determine how the brake will operate. The interaction is
Custom Data Set
BR unit is not satisfied with data received from the othe
r
components, the Instrument Cluster will illuminate the red IBR warning light
must be shut down and restarted before the
IBR system will be fully functional: Remove the Lanyard, wait 10
start the engine.
trument cluster and mimic
to CAN) data adaptor; the
re
-transmits CAN