Manual

MoTeC Appendices
M400 Pin Sea-Doo Pin Function
Parameters
Aux8 A34 A37 0: Off
AT6 B19 B19 31: Start/Stop
Switch
Polarity 1
DIG1 B08 K08 1: Speed Measure
Measurement Type 3
Calibration 1116
Active Edge 0
Noise
Window 0
Noise Increment 0
Noise Limit 0
DIG2 B09 B09 8: Ignition Switch
Logic Polarity 0
Delay 1.0
Latch 0
DIG3 B10 B07,B30 29: Monitor
Polarity 0
DIG4 B11 B23,B33 29: Monitor
Polarity 0
Note 2 – Calibration Tables
For the following pins the calibration table is available in the provided
Maps.
M400 Pin Sea-Doo Pin Function
AT1 B03 A07 Air Temperature
AT2 B04 A11 Engine Temperature
AT3 B05 A10 Exhaust Water Temp Sensor
AT4 B06 B34,A31 (2004)
Crankcase Pressure Switch
(2007) VTS Trim Level
AT5 B07 A06 Oil Pressure Switch
AV1 A14 A24 Throttle Position
AV2 A15 A12 Manifold Pressure Sensor
AV3 A16 B08,K06 (2007)
External Water Temperature
AV4 A17 B13 (2007) Fuel Tank Level
59
Parameters
Polarity 1
Measurement Type 3
Calibration 1116
Active Edge 0
Window 0
Noise Increment 0
Noise Limit 0
Logic Polarity 0
Polarity 0
Polarity 0
For the following pins the calibration table is available in the provided
Base
Crankcase Pressure Switch
External Water Temperature