User's Guide

48 Chapter 3 Using your Tablet PC
Using Wireless Broadband
Use the information in this section to set up a Wireless Broadband connection. Wireless
Broadband access requires a service contract from a Wireless Broadband service provider.
For more information, see “Wireless Broadband” on page 16.
WARNING: FAA regulations require that you disable any wireless connection when
traveling by air. Failure to disable the wireless connection on the Tablet PC while traveling
by air can cause communications problems with aircraft instruments.
Activating your Wireless Broadband service
Before you can use the Wireless Broadband service, you must activate your service with the
service provider you chose when you ordered your Tablet PC.
You may be able to activate your service using the connection manager, or you may have to
call your service provider to activate. For more information about starting the connection
manager, see the Wireless Broadband document in the Tablet PC box.
Enabling Wireless Broadband
Before you can establish a Wireless Broadband connection, you must enable the Wireless
Broadband adapter. You can enable the Wireless Broadband adapter using Motion
Dashboard.
To enable Wireless Broadband
1. Open the Motion Dashboard to the Wireless panel (page 20).
2. Select the Enable Broadband Wireless check box.
Starting the connection manager
The connection manager software is preinstalled on your Tablet PC based on the service
provider you chose when you ordered the Tablet PC.
To start the connection manager
• Double-tap the connection manager shortcut on your desktop.
For more information, see the connection manager help.
Note: The connection manager software you use depends on your wireless service provider.