User Manual

ManualsBrandsMotion Pro ManualsFor motorcycles08-0058

I08-0058 1 of 4 09/2010

Chain Breaker and Riveting Tool P/N 08-0058

Thank you for purchasing the Motion Pro Chain Breaker and Riveting Tool. This tool is designed for light to

medium-duty use. It will break chains up to size #630, press master link plates on chains up to #530, and rivet

hollow nosed master link pins on chains up to #630. For heavy-duty applications or for solid-nosed riveting

please refer to Motion Pro part number 08-0135

Jumbo Chain Tool and part number 08-0142 Quad Stake

Riveting Tool.

IMAGE A

A – Body, C08-058A F – Spring, C08-001D K – Lower Guide for 2.2mm tip

B – Alignment Bolt, C08-058B G – 2.2mm Breaking Tip, 08-0059 L – Press Plates (set), 08-0067

C – Push Bolt, C08-058C H – 2.9mm Breaking Tip, 08-0060 M – Large Anvil, C08-058D

D – Lever I – 3.8mm Breaking Tip, 08-0061 N – Small Anvil

E – Handle J – Upper Guide for 2.2mm tip O – Rivet Tip, 08-0062

-Read all instructions for each procedure before beginning. Improper use of the tool can cause

breakage.

-Make sure the tool is clean and apply grease to all threads before assembling and using. This will help the

tool operate more smoothly and allow you to feel tension when using the tool.

When breaking #520 or larger drive chain, it is recommended to grind off the rivet heads first. This will

significantly reduce the load on the tool and help prevent premature wear or damage to the breaking tips.

-All tightening procedures are to be performed

by hand only, using the lever or a 14mm wrench. Do not use

extensions or power tools

of any kind or the tool may be damaged.

Summary of content (4 pages)

PAGE 1
Chain Breaker and Riveting Tool P/N 08-0058 Thank you for purchasing the Motion Pro Chain Breaker and Riveting Tool. This tool is designed for light to medium-duty use. It will break chains up to size #630, press master link plates on chains up to #530, and rivet hollow nosed master link pins on chains up to #630. For heavy-duty applications or for solid-nosed riveting please refer to Motion Pro part number 08-0135 Jumbo Chain Tool and part number 08-0142 Quad Stake Riveting Tool.
PAGE 2
BREAKING CHAINS Use only the correct breaking tip for your application, or you will damage the tip. 2.2mm breaking tip for most cam chains. 2.9mm breaking tip for chains #25 - #35 only. 3.8mm breaking tip for drive chains #428 - #630. Assemble the tool as shown in Image B and the diagram below for breaking chains. Thread the alignment bolt into the body. Insert the breaking tip into the spring and drop them into the alignment bolt with the spring under the tip head.
PAGE 3
PRESSING SIDE PLATES Assemble the tool as shown in Image C for pressing side plates. The alignment bolt will be threaded into the body, with the breaking tip, spring and push bolt removed. The press plate with the holes will be inserted into the alignment bolt, and the press plate with the groove will be placed in the hole in the tool body.
PAGE 4
RIVETING CHAIN PINS Assemble the tool as shown in Image E for riveting hollow-nosed master link pins. Thread the alignment bolt into the body. Insert the rivet tip into the spring and drop them into the alignment bolt with the spring under the tip head. (Refer to internal diagram with Image B). Thread the push bolt into the alignment bolt above the tip. Place the anvil in the hole in the tool body per Image G. (Small anvil used for up to 3-series cam chains only).