Service manual

1.1 The operation notice:
1.Always replace gasket, O ring, cotter, pins and clip whenever reassembled.
2.When tighten screws or nuts, lock tightly as per specified locking torque, and in the sequence
of
cross direction.
3.Use PGO, or PGO Recommended parts.
4.After dismantling please wash all parts necessary for checking and grease all
contact surfacewhen reassembling.
5.Usegrease recommended by P.G.O.
6.When removing battery, please dismantle the negative pole (-) first, when
assemblingplease connect positive pole (+) first.
6.Before installing a new fuse, confirmthe specification is correct or not.
7.After reassembling, please re-check that all connecting point, locking parts,
circuits, polar characteristics are good, before selling out.