Service manual

Cylinder Head

Removal and disassembly

1. Remove the cylinder head

Procedure:

A. Remove 4 set screws on the cylinder head to take

out the cylinder head cap.

B. Remove 2 set screws of the chain adjuster and

take out brackets and pads supporting the idle

controller of the chain adjuster.

C. Remove 1 set screw of the camshaft sprocket and

take out the camshaft sprocket and the turning

disk.

D. Disconnect the water outlet of the temperature

controller (water tank and water pump). Remove

6 units of set screws, nuts and washers on the

cylinder head.

Set screws

Bracket

Chain adjuster

Set screws