Service manual

V Belt Driver 8
57
Left cover / drive belt assembly
A. Remove 3 set screws on the left cover cap and take
out it.
B. Remove 9 set screws on the left cover and take out
it.
C. Remove 1 set nut on the front drive unit and take
out parts such as drive flank, mobile drive flank,
mobile drive flank hub, and sleeve. Remove 1 set
nut on the rear drive unit and take out parts such as
bearing sleeve, clutch housing, driven belt pulley,
and belt.
Installation
1. Install the said parts in a reverse order.
2. Cautiously handle the belt during assembly.
A. Characters on the belt should point the
driving direction.
B. To avoid a drive flank wrongly locked,
the driven belt pulley should be
inserted first and allows the belt to be
loosened during the drive flank
attached.
Set screws
Driving direction
Set screws
Drive flank
Belt
Clutch
Clutch
housing
O-rings
Bearing sleeve
Driven belt
pulley
Mobile
drive flank
Mobile drive
flank hub
Spacer
ring