Service manual

Final Speed Gear 10
66
Final drive gear
Steps for removal:
1. Remove the drain plug bolt and drain the gear
oil.
2. Remove 7 set screws on the gear box cover;
take out the gear box cover.
3. Remove the rear shaft.
4. Final gear
5. Idle gear and flat washer
6. Drive shaft
Please always renew any washer during assembly.
Gear box cover
Steps for removal:
1. Check each bearing which is removed from
the final drive system.
2. Change any useless bearing, if any.
3. Remove the C-ring with a C-ring puller.
4. Remove the used bearing with a bearing
puller.
5. Use the tool for installation of a bearing during
assembly.
Set screws
Rear shaft
Final gear
Flat washer
Idle gear
Dowel pin
Drive shaft
Seal
Idle gear
b
earin
g
Drive shaft
b
earin
g
C-ring
Rear shaft
b
earin
g
Seal
Idle
gear
b
earin
g
Drive shaft
b
earin
g
C-ring
Smooth face
down
Rear shaft
b
earin
g