Service manual

Charge, Ignition, and Start-up

Check:

1. Battery

 Voltage check

A. Use a multi-meter or a voltage meter to test a battery’s

voltages.

B. Voltage:

 Full charge: >12.8V

 Under charge: <12.0V

 Use a clamp meter to measure charging

current by turning the rotary switch to the

“current” function and hooking the fuse’s “+”

terminal for measurement of charging current.

 Charge

A. Connect a charger’s “+” to the battery’s “+” terminal

B. Connect a charger’s “-” to the battery’s “-” terminal

2. Charging system

System circuits

Check circuits for charging

Check any single part for any measured value incorrect; check wiring in the event of the part normal.

Change the power regulator for all situations normal.

Standard Max.

Charging Current 1.2A 5A

Charging Time 5~10 hours 1 hour

Item Method for Measurement Standard

Main switch Power(Orange) & ECU(Green)→GUD(Black) Battery voltage (KEY ON)

Battery wiring Battery(Red)→Battery(Black) Battery voltage

Charge coil ACG(Yellow)→ACG(Yellow) 0.3~0.5Ω