Service manual

92 Chassis 14
92
 Remove the rear wheel

Removal
A. Remove the seat assembly; disconnect the Lambda
sensor connector.
Tool: 10” T-type wrench
B. Remove the exhauster assembly; keep the Lambda
sensor body not be collided during removal.
Tool: 12” T-type wrench
C. Remove the axle cover.
Tool: Slotted screwdriver
D. Cautiously remove and lay the brake caliper and clips
on the brake oil hose. Do not press the brake lever
with the caliper separated from the brake disk.
Tool: 12” & 10” T-type wrenches
E. Remove screws on the shock absorber support and
nuts on the rear axle.
Tool: 12” T-type wrench; 24” socket wrench; air wrench
F. Remove screws on the rear fork and the fender; take
out the rear fork.
Tool: 12” & 10” T-type wrenches
G. Remove the rear shock absorber or the rear wheel
cannot be removed.
Tool: 14” box spanner
H. Remove the shock absorber and the rear wheel
assembly.
I. Cautiously preserve the spacer ring on the rear axle for
installation later.
 Install the rear wheel
A. Install the spacer ring on the rear wheel.
B. Do not strike the Lambda sensor during installation
of the exhauster.
C. Install all parts in a reverse order.