User Manual

SC20-A_Manual_R1.0 Confidential / Released 49 / 49

14.7. Notice to Host Product Manufacturer:

Any deviation(s) from the defined parameters of the antenna trace, as described by this instruction,

host product manufacturer must notify us that you wish to change the antenna trace design. In this

case, a Class II permissive change application is required to be filed by us, or you (host

manufacturer) can take responsibility through the change in FCC ID and IC ID (new application)

procedure followed by a Class II permissive change application.

14.8.Labelling Instruction for Host Product Integrator

Please notice that if the FCC and IC identification number is not visible when the module is installed

inside another device, then the outside of the device into which the module is installed must also

display a label referring to the enclosed module. This exterior label can use wording such as the

following:“Contains FCC ID: 2AMH4SC20A ” and “Contains IC: 29364-SC20A ” any similar wording

that expresses the same meaning may be used.15.19 and RSS-Gen Labelling requirements shall

be complied on end user device. Labelling rules for special device, please refer to §2.925, § 15.19

(a)(5) and relevant KDB publications. For E-label, please refer to §2.935.

14.9.Installation Notice to Host Product Manufacturer

The OEM integrator is responsible for ensuring that the end-user has no manual instruction to

remove or install module.

The module is limited to installation in mobile application, a separate approval is required for all

other operating configurations, including portable configurations with respect to §2.1093 and

difference antenna configurations.

15.0.Antenna Change Notice to Host manufacturer

If you desire to increase antenna gain and either change antenna type or use same antenna type

certified, a Class II permissive change application is required to be filed by us, or you (host

manufacturer) can take responsibility through the change in FCC ID and IC ID (new application)

procedure followed by a Class II permissive change application.

FCC other Parts, Part 15B Compliance Requirements for Host product manufacturer This modular

transmitter is only FCC authorized for the specific rule parts listed on our grant, host product

manufacturer is responsible for compliance to any other FCC rules that apply to the host not

covered by the modular transmitter grant of certification. Host manufacturer in any case shall ensure

host product which is installed and operating with the module is in compliant with Part 15B

requirements. Please note that For a Class B or Class A digital device or peripheral, the instructions

furnished the user manual of the end-user product shall include statement set out in §15.105

Information to the user or such similar statement and place it in a prominent location in the text of

host product manual. Original texts as following:

For Class B:

Note: This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates, uses

and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more of the

following measures: