User Manual

SAFETY DATA SHEET
According to the Hazardous Products Regulations
MotoMaster Synthetic Motor Oil 5W-30
(SN/GF-5)
Version
1.1
Revision Date:
19.02.2020
SDS Number:
800010035987
Print Date: 25.03.2020
Date of last issue: 03.06.2019
Date of first issue: 03.06.2019
7 / 15
800010035987
CA
time maybe acceptable so long as appropriate maintenance
and replacement regimes are followed. Glove thickness is not
a good predictor of glove resistance to a chemical as it is
dependent on the exact composition of the glove material.
Glove thickness should be typically greater than 0.35 mm
depending on the glove make and model.
Eye protection
:
If material is handled such that it could be splashed into eyes,
protective eyewear is recommended.
Skin and body protection
:
Skin protection is not ordinarily required beyond standard
work clothes.
It is good practice to wear chemical resistant gloves.
Thermal hazards
:
Not applicable
Protective measures
:
Personal protective equipment (PPE) should meet recom-
mended national standards. Check with PPE suppliers.
Environmental exposure controls
General advice
:
Take appropriate measures to fulfill the requirements of rele-
vant environmental protection legislation. Avoid contamination
of the environment by following advice given in Section 6. If
necessary, prevent undissolved material from being dis-
charged to waste water. Waste water should be treated in a
municipal or industrial waste water treatment plant before
discharge to surface water.
Local guidelines on emission limits for volatile substances
must be observed for the discharge of exhaust air containing
vapour.
SECTION 9. PHYSICAL AND CHEMICAL PROPERTIES
Appearance
:
liquid
Colour
:
amber
Odour
:
Slight hydrocarbon
Odour Threshold
:
Data not available
pH
:
Not applicable
pour point
:
-36 °C / -33 °F
Method: ASTM D97
Initial boiling point and boiling
range
:
> 280 °C / 536 °F
estimated value(s)