Datasheet

www.symcom.com • 800-843-8848 • fax: [phone]
45
Available Models:
Features:
• DIN rail or surface mountable
• Unique probe protection algorithm
• Invertible relay logic
• 4.7k to 100 kΩ adjustable sensitivity
• Microcontroller based
• 2 relay contacts
• LED status indicator
A pprovals:
460-15-100-SLD
Specications
The Model 460-15-100-SLD
is a seal-leak detector to sense seal failures on
submersible pumps. A microcontroller-based
relay that monitors the shaft seal of a submersible
pump motor. A resistive probe is installed in the
seal cavity. If water leaks into the pump, the
resistance measured by the probe decreases. When
the resistance drops below the sensitivity setpoint,
the unit will trip and the relay contacts will
change state. Output relay logic can be reversed
by removing an external jumper. The unit will
automatically reset when a fault is cleared.
For more information see:
See Appendix A, page 69, Figure 11 for dimensional
drawing.
See Appendix B, page 79, Figure 40 for typical
wiring diagrams.
Surge
IEC ...........................................IEC 61000-4-5, Level 3, 4kV line-to-line;
Level 4, 4kV line-to-ground
ANSI/IEEE ....................................C62.41 Surge and Ring Wave Compliance to
a level of 6kV line-to-line
Hi-Potential Test ...............................Meets UL508 (2 x rated V + 1000 V for 1 min.)
Safety Marks
UL ............................................UL508 (File #E68520)
CE ............................................IEC 60947
Enclosure ......................................Polycarbonate
Dimensions ....................................3.5” H X 2.084” W X 2.350” D
(88.9 x 52.93 x 59.69mm)
Weight ........................................1 lb. (16 oz., 453.59 g)
Mounting Method ..............................35mm DIN rail or Surfact Mount
(#6 or #8 screws)
*Note: 50Hz will increase all delay timers by 20%
Model 460-15-100-SLD
single-channel seal-leak detector, din rail mount, adjustable sensitivity setpoint
Seal-Leak Detector
Surge
IEC ........................................ IEC 61000-4-5, Level 3, 4kV line-to-line;
Level 4, 4kV line-to-ground
ANSI/IEEE C62.41 Surge and Ring Wave Compliance
to a level of 6kV line-to-line
Hi-Potential Test ............................ Meets UL508 (2 x rated V + 1000 V for 1 min.)
Safety Marks
UL ......................................... UL508 (File #E68520)
CE ......................................... IEC 60947
Enclosure ................................... Polycarbonate
Dimensions ................................. 3.5”H x 2.084”W x 2.35”D
(88.9 x 52.93 x 59.69mm)
Weight ..................................... 1 lb. (16 oz., 453.59 g)
Mounting Method ........................... 35mm DIN rail or Surfact Mount
(#6 or #8 screws)
*Note: 50Hz will increase all delay timers by 20%
Input Characteristics
Control Voltage .............................. 110/120VAC nominal
Frequency .................................. 50*/60Hz
Functional Characteristics
Sensitivity .................................. 4.7k-100kΩ
Probe Sense Voltage ......................... 5vdc pulsed
Output Characteristics
Output contact Rating – (Two Form A - DPST)
Pilot Duty .................................. 360VA @ 240VAC
General Purpose ............................. 8A @ 240VAC
General Characteristics
Ambient Temperature Range
Operating .................................. -40° to 70°C (-40° to 158°F)
Storage ..................................... -40° to 80°C (-40° to 176°F)
Maximum Input Power ....................... 2 W
Class of Protection ........................... IP20, NEMA 1 (finger safe)
Relative Humidity ........................... 10-95%, non-condensing per IEC 68-2-3
Terminal Torque. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 in.-lbs.
Wire ....................................... AWG 12-20 AWG
Standards Passed
Electrostatic Discharge (ESD) .................. IEC 61000-4-2, Level 3, 6kV contact, 8kV air
Radio Frequency Immunity, Radiated .......... 150MHz, 10 V/m
Fast Transient Burst IEC ...................... 61000-4-4, Level 3, 3.5kV input power
and controls
CATALOG_SYMCOM_2014.indd 45 6/10/14 11:06 AM