Owner`s manual

Revision 2 Page 10 of 14
HOW TO USE THE ELECTRIC REVERSE:
1. Turn the ignition on and start the bike. Never use the reverse when the bike is not running.
2. Put the bike in neutral.
3. Turn the activation switch on and look for the red indicator light on the switch to illuminate. See
switch location in Figure 7. NOTE: With the activation switch on and the neutral light on, the
function of your horn button and start button has been changed to operate the reverse.
Figure 7: Activation Switch Location. View of Right Side of Bike
4. Press and hold the horn button. The horn should not sound.
5. Check that there is a clear path behind you. And announce that you are backing up to anyone
nearby.
6. Press the start button to back up. Warning: Always check that the bike is in neutral, the activation
switch is illuminated, and press and hold the horn button before pressing the start button. If the
horn sounds, do not press the start button. This could cause damage to your motorcycles starting
system.
7. Disable the reverse by switching the activation switch off. The function of your horn and start
buttons are returned to normal. The red indicator light on the activation switch should be off.
Repeated use without charging time, stalling the reverse for too long or other abuse will cause the
integrated circuit breaker(s) to trip. They are located under the seat and must be manually reset for the
reverse to function again. Warning: The breakers will not protect the reverse against all forms of abuse.
Be sure to follow the guidelines outlined in this manual. If the breakers flip, the reverse is being used far
and above its intended use. Repeated operation of this nature will void the warranty for the electric
reverse system. See Figure 8 for instructions on resetting the breaker(s). If you have style A there are two
breakers. If you have style B there is only one breaker.
ACTIVATION
SWITCH