Owner`s manual

Revision 2 Page 9 of 14
Figure 6: Properly Installed Draw Bar Safety Pin
ELECTRIC REVERSE (IF EQUIPPED)
If used within the recommendations below, the electric reverse will meet all of your expectations.
Before reversing, always check that the path behind the trike is clear and announce that you are backing
up to anyone nearby. Be sure to follow these guidelines will using your reverse:
 The electric reverse should not be operated longer than 15 seconds at a time.
 The bike should be driven several miles in between reverse uses to allow the battery to fully
charge. Use the motorcycles voltmeter as a guide.
 Do not stall the reverse for more than 3 seconds. If you encounter a hill or curb that can not be
climbed, remove as much weight as possible and try again. If the reverse still does not climb the
hill, you may be asking it do something beyond its capability. Do not make further repeated
attempts.
 Always operate the reverse while sitting on the driver’s seat with both feet on the floor boards
and both hands on the handlebars.
Extended use and limited charging can and will lead to electric reverse and battery damage. Motor
Trike is not responsible for damage that is caused by exceeding the recommended duration or frequency
of use.
The electric reverse will not perform well if the motorcycles battery is in poor condition or if the
battery doesn’t have a sufficient charge.
PROPERLY
INSTALLED DRAW
BAR WITH SAFETY
CLIP
ANTI-RATTLE BOLT
RECIEVER
TUBE
DRAW BAR