Instructions / Assembly

Installation Tips
Your new floor is a free-floating floor system that requires no glues or
fasteners to install. Make sure you are installing your floor over a sound,
solid surface. Patch or fill any very large holes, or grind any protrusions
from the substrate. Your modular floor is made with the latest technology in
high-tech composite polymers. It is very strong, light weight, and can
support a great deal of weight. The following are a few key tips that will
make your installation process trouble free.
 Start your installation from either side of the inner door opening and
work inward. Be sure to start on the side that has the longest and
straightest wall.
 During your floor installation, keep nothing on top of the floor as your
floor will self correct as you go.
 Do your entire trimming at the hottest part of the day and with nothing
on top of the floor.
 Be sure to leave a minimum of 1/2" space between the floor edge and
wall (or anything such as cabinets, door rails, steps, etc). Your floor
edge should never be up against anything.
 When bringing everything back into your newly surfaced area, do so at
the hottest part of the day, when the floor is fully expanded to its
maximum.
 Never try to glue down or fasten your floor, it is designed to expand
and contract.
 Save your trim pieces, they may be able to be used in other areas of
your garage install.
 Day to day cleaning is performed by sweeping and mopping with water
and a degreaser. Solvent-based solutions can be used to clean
stubborn areas without harming the flooring. To aid in separating the
floor for removal, slide a broom handle under the floor at a joint and
slide it along the joint to separate the locks.