User's Manual

Activating the Wireless Foot Pedal
Each wireless foot pedal and wireless handheld remote has a unique serial
number, and each wireless controller must be synced individually to the trolling
motor receiver. The trolling motor receiver can sync up to 40 wireless
controllers. This ensures that the trolling motor will respond to commands only
from designated controllers. Follow the instructions below to activate a wireless
controller with your trolling motor. For erasing and reprogramming information,
refer to Foot Pedal and Handheld Remote Reprogramming and Battery
Replacement.
IMPORTANT: To activate multiple foot pedals or remotes, the motor must be
unplugged from the power source and then plugged back into the power source
between activating each control device.
1.
Install the batteries into the wireless foot pedal. Refer to Foot Pedal and
Handheld Remote Reprogramming and Battery Replacement.
2. Connect the battery cables to the battery, or plug in the battery cable to a
power source. Within ten seconds of connecting the battery cables to their
terminals, press and hold the propeller and anchor buttons on the
wireless foot pedal simultaneously.
3. Listen for a multitone beep, indicating that the receiver has synced the
electronic serial number.
a -
Anchor button (foot
pedal on/off)
b -
Propeller button
(propeller on/off)
4.
To turn the pedal on or off, press and hold the anchor button. One beep
from the foot pedal indicates that the foot pedal is turned on, two beeps
indicate that the foot pedal is turned off.
Activating the Handheld Remote
1. If the trolling motor battery cables are connected, disconnect the battery
cables from the trolling motor battery, starting with the negative (–) lead.
a
b
51767
PRODUCT INSTALLATION, WIRING, AND BATTERY
INFORMATION
18 eng