User's Manual

Symptom Possible Cause Resolution
Difficulty removing
propeller
Bent propeller pin
Hold one blade and lightly tap the
opposite blade with a rubber
mallet.
Use a putty knife on both sides of
the propeller to apply equal
pressure.
Bent armature
shaft
Contact a Service Center.
Troubleshooting the Foot Pedal and Handheld Remote
ERASING THE RECEIVER'S MEMORY
Erasing the receiver's memory will erase all electronic ID numbers that are
stored in the receiver's memory.
1. Plug in the battery cable to a power source. In less than ten seconds,
press the left arrow, right arrow, +, and – buttons on the handheld
remote simultaneously.
2. Listen for a long beep indicating the receiver has erased all stored
electronic ID numbers.
NOTE: If all four buttons on the remote are not pressed simultaneously within
ten seconds, or a long beep is not heard, unplug the battery cables from the
power source and then refer to Activating the Wireless Foot Pedal and
Activating the Handheld Remote in the Product Installation, Wiring, and
Battery Information section of this manual.
REPROGRAMMING THE WIRELESS FOOT PEDAL OR REMOTE
NOTE: This activation procedure applies to the foot pedal and handheld
remote.
IMPORTANT: To activate multiple foot pedals or remotes, the motor must be
unplugged from the power source and then plugged back into the power source
between activating each control device.
1. Unplug the battery cables from the power source. Wait 30 seconds and
then plug the motor into the power source.
2.
In less than ten seconds, press and hold the left arrow and right arrow
buttons on the handheld remote. For the foot pedal controller, hold the
propeller and anchor button simultaneously.
FOOT PEDAL BATTERY REPLACEMENT
Battery required: Two AA alkaline batteries
OWNER SERVICE ASSISTANCE
eng 41