User's Manual

MOTORGUIDE WIRELESS

90-MM5997 For Questions, Contact Consumer Affairs at #1-920-929-5040 11

4) Place the mount base plate on the boat deck aligning

the holes on the plate to the holes on the deck. Install

the four (4) stainless steel mounting bolts through

each of the mounting holes.

5) Install the four (4) stainless steel washers and nuts on

the bottom side of the deck and tighten securely.

6) Remove the packaging material, in the box, from around the trolling motor.

7) Lift the motor and mount out of the box, turn the mount upright and and lay

it on a flat surface. Loosen the mount locking knob, located at the back of

the mount housing, until it can pivot approximately 25 degrees.

8) The motor is shipped with the

lower unit and mount in the stowed position, but the lower unit must be

placed into the locking cradle before proceeding. Pull up on the release

handle to unlock the transmission. Slide and pivot the lower unit as

needed to snap the lower unit inside the locking cradle.

Mount Locking

Knob

Lower Unit in Stowed

Position; Lower Unit

inside Cradle

Depth Collar

9) Lift the motor and mount and

place it over the mount base

plate. The end of the mount

housing with the lower unit

cradle and lower unit is

placed forward over the

mount base plate. Guide the

end of the mount with the

lower unit at

approximate 10

downward angle

over the base plate until the pivot pin on

the underside of the mount fits into the

large flange hook on the base plate.

Lower Unit Cradle

Placed Forward over

Mount Base

Front of Base Plate

Large Flange Hook &

Pivot Pin