EN MCONNECT BRIDGE MCONNECT USER’S AND INSTALLER’S MANUAL v1.2 REV.
00. CONTENT 01. SAFETY INSTRUCTIONS INDEX ATTENTION: 01. SAFETY INSTRUCTIONS This product is certified in accordance with European Community (EC) safety standards. 1B 02.
01. SAFETY INSTRUCTIONS GENERAL WARNINGS • This manual contains very important safety and usage information. very important. Read all instructions carefully before beginning the installation/usage procedures and keep this manual in a safe place that it can be consulted whenever necessary. • This product is intended for use only as described in this manual.
01. SAFETY INSTRUCTIONS September 2009. • Attach the permanent label for the manual release as close as possible to the release mechanism. • Disconnect means, such as a switch or circuit breaker on the electrical panel, must be provided on the product’s fixed power supply leads in accordance with the installation rules. • If the product to be installed requires power supply of 230Vac or 110Vac, ensure that connection is to an electrical panel with ground connection.
03. CONTROL BOARD 02. CONNECTIONS SCHEME MCONNECT BRIDGE CONNECTION TO A MOTORLINE CONTROL BOARD MCONNECT BRIDGE was developed to connect mobile devices (smartphone) and all Motorline automatisms in a home.
03. CONTROL BOARD 05. CONFIGURATION TECHNICAL SPECIFICATIONS ADD MODULE IN IN THE APP 1 • Open MCONNECT app. 2 • Login. 3 • On the home page press the "+" button at the top right. 4 • Press Add new MCONNECT. 5 • Accept all requested permissions. 6 • Turn on the power. 7 • Check that the module is in pairing mode (flashing purple). Note • if it is not in pairing mode it is necessary to reset. 8 • Read the QR Code on the module box.
05. CONFIGURATION RESET When resetting, the device is no longer connected to the account it is associated with in the application. Press the reset button until the LED changes to pairing mode (flashing purple), which will confirm successful operation. Reset button 06. TROUBLESHOOTING INSTRUCTIONS FOR FINAL CONSUMERS/TECHNICIANS PROBLEM SOLUTION The LED reader does not light up Check that the power is connected correctly.
