User Manual

6
EN
05. CONFIGURATION
06. TROUBLESHOOTING
Reset button
When resetting, the device is no longer connected to the
account it is associated with in the application.
Press the reset button until the LED changes to pairing
mode (flashing purple), which will confirm successful
operation.
RESET
INSTRUCTIONS FOR FINAL CONSUMERS/TECHNICIANS
PROBLEM SOLUTION
The LED reader does not light up Check that the power is connected correctly.
The module is not in pairing mode
(LED flashing purple) and I haven't
configured it yet
Press the Reset button located on the back of the
module, until it switches to pairing mode.
The module has the red LED
Make sure the network you configured the module on is
available.
Check if you have coverage of the network to which the
module is connected.
Check if the network you have configured the module has
Internet access.
The module has the blue LED
Check if the network you configure the module has
Internet accesst.
The output does not change state Check that the connections are correct.
The switch does not change the state
output
Make sure the connections are correct.
Check that the input has between 12 and 24V when active.