User's Manual

ii
Disclaimer
Statements included in this manual indicating support pro-
vided by Motorola are subject to changes at any time.
Motorola reserves the right to make changes to this manual.
Regulatory Requirements
The Federal Communications Commission (FCC) requires
application for certification of digital devices in accordance
with CFR Title 47, Part 2 and Part 15. This includes Elec-
tromagnetic Energy Exposure (EME) testing. As the D1000
PCMCIA modem is not a stand-alone transceiver but is a
PC card, the D1000 cannot be tested by itself for EME cer-
tification and was tested while it is inserted in a Laptop Per-
sonal Computer.
Regulatory Statement
The following safety precautions must be observed during
all phases of the operation, usage, service or repair of any
D1000 modem.
Users of the D1000 modem are advised to convey the fol-
lowing safety information to users and operating personnel
supplied with the product. Failure to comply with these pre-
cautions violate safety standards of design, manufacture
and intended use of the product. Motorola assumes no lia-
bility for customer failure to comply with these precautions.
1. The D1000 must not be mechanically nor electrically
changed.
2. The D1000 has been designed the meet the EMC
requirements of ETS 300 342.
3. The D1000 meets the safety requirements of EN60950.
4. Systems using the D1000 will be subject to mandatory
EMC testing under directive 89/336/EEC.
THIS RADIO PRODUCT MEETS THE
GOVERNMENT'S REQUIREMENTS
FOR EXPOSURE TO RADIO WAVES.
Your wireless radio product is a radio transmitter and
receiver. It is designed and manufactured not to exceed the
emission limits for exposure to radio frequency (RF) energy
set by the Federal Communications Commission of the
U.S. Government. These limits are part of comprehensive
guidelines and establish permitted levels of RF energy for
the general population. The guidelines are based on stand-
ards that were developed by independent scientific organi-
zations through periodic and thorough evaluation of
scientific studies. The standards include a substantial safety
margin designed to assure the safety of all persons, regard-
less of age and health. The exposure standard for wireless
mobile phones employs a unit of measurement known as
the Specific Absorption Rate, or SAR. The SAR limit set
by the FCC is 1.6W/kg.* Tests for SAR are conducted
using standard operating positions reviewed by the FCC
with the device transmitting at its highest certified power
level in all tested frequency bands. Although the SAR is
determined at the highest certified power level, the actual
SAR level of the device while operating can be well below
the maximum value. This is because the radio device is
designed to operate at multiple power levels so as to use
only the power required to reach the network. In general,
the closer you are to a wireless base station antenna, the
lower the power output. Before a radio product is available
for sale to the public, it must be tested and certified to the
FCC that is does not exceed the limit established by the
government-adopted requirement for safe exposure. The
tests are performed in positions and locations (e.g. at the ear
and worn on the body) as required by FCC for each model.
The highest SAR value for this radio product when tested
for use during packet data is 1.52 W/kg. The FCC has
granted an Equipment Authorization for this model phone
with the FCC and can be found under the Display Grant
section of http:/ /www.fcc.gov/oet/fccid after searching on
FCC ID IHDT6EG1. The standard incorporates a substan-
tial margin of safety to give with all reported SAR levels
evaluated as in compliance with the FCC RF exposure
guidelines. SAR information on this model phone is on file
web-site at http://www.wow-com.com. Additional informa-
tion on Specific Absorption Rates (SAR) can be found on
the Cellular Telecommunications Industry Association
(CTIA) * In the United States and Canada, the SAR limit
for mobile phones used by the public is 1.6 watts/kg (W/kg)
averaged over one gram of tissue. additional protection for
the public and to account for any variations in measure-
ments.
Safety and General Information
IMPORTANT INFORMATION ON SAFE AND EFFI-
CIENT OPERATION. READ THIS INFORMATION
BEFORE USING YOUR RADIO PRODUCT.
The information provided in this document supersedes the
general safety information in user's guides published prior
to December 1, 2002.
Exposure To Radio Frequency (RF) Energy
Your phone contains a transmitter and a receiver. When it is
ON, it receives and transmits RF energy. When you com-
municate with your phone, the system handling your call
controls the power level at which your phone transmits.
Your Motorola phone is designed to comply with local reg-
ulatory requirements in your country concerning exposure
of human beings to RF energy.
Operational Precautions
To assure optimal phone performance and make sure
human exposure to RF energy is within the guidelines set
DRAFT (01.08.04)