User's Manual
21
Before Using the FOMA Terminal
Connecting the FOMA
Terminal and a PC
Inserting
Before using the FOMA terminal for the first
time, you must install the M2501 HIGH-SPEED
driver following the steps in “Communication
Configuration File (Driver)” (P24).
• Install the UIM to the FOMA terminal before using. →P17
a
Turn on the PC
b
Hold the FOMA terminal with the label
side up and slide straight into the PC
card slot
• The location of a PC card slot and the way the card is
inserted vary depending on the PC.
• Insert the card all the way in the PC card slot securely.
c
Double-click the card icon in the task
tray on the Desktop
• If “FOMA M2501 USB Host Controller” appears, the
FOMA terminal is correctly installed.
• If the above name does not appear after a while, turn off
your PC, verify the connection and try again.
• Remove the FOMA terminal from the PC when you move
the PC. Keep the FOMA M2501 terminal in its case when
you carry it.
• Do not apply force to the exposed portion of the card and
do not use the section as a handle while the card is
inserted in the PC. Doing so may cause injury, failure or
damage.
• Be aware of the remaining battery level when using a PC
on its battery. The FOMA terminal operation may become
unstable when the remaining battery level is low.
▼
Connecting the FOMA Terminal and a PC