User's Manual

26
Setting Up
l
Install the other three drivers
Install all three drivers referring to Steps 8-11.
For Windows 2000
a
Start Windows and insert the FOMA
M2501 HIGH-SPEED CD-ROM to the PC
b
Click [スタート (Start)] y “ファイル名を指
定して実行 (Select file name and run)”
c
Click [参照 (Browse)] to specify the file
setup.exe, then click [OK]
• Specify the file “<CD-ROM drive letter>:/Drivers/setup.
exe” (the CD-ROM drive letter varies depending on the
configuration of your PC).
d
Verify the destination folder and click
[Install]
• [Browse] : You can change the destination folder.
However, you can specify only folders on the local hard
disk. Other folders (on a network drive or removable
media) cannot be specified.
e
Click [Yes]
• Click [はい (Yes)] because this software behaves in the
same way as a software with a digital signature.
f
Click [OK]
g
Insert the FOMA terminal into the PC
card slot (P21)
h
Click [次へ (Next)]
i
Select “デバイスに最適なドライバを検索
する （推奨） (Search for the most suitable
driver) (Recommended))” and click [次へ
(Next)]
j
Check “場所を指定(Find in)” and click
[次へ (Next)]
Screen to be replaced
Screen to be replaced
Screen to be
replaced
Installing the Driver