User's Manual

42
Setting Up
AT＊DANTE Show the signal strength at the
FOMA terminal.
=0 : Out of service area
=1 : One antenna bar
=2 : Two antenna bars
=3 : Three antenna bars
AT＊DANTE
＊DANTE : 3
OK
AT＊DANTE=?
＊DANTE : (0-3)
OK
(Show the range of
values that can be
displayed)
AT＊DGPIR=<n>
[?] [=?]
The setting of this command
becomes valid when a call is
dialed. 184/186 can also be
added to the APN number even
for the setting in a dial-up
network.
n=0 (default) : Use APN as it
is.
n=1 : Add “184” to APN
(always hide).
n=2 : Add “186” to APN
(always show).
AT＊DGPIR=0
OK
AT＊DRPW Show an indicator of the
received radio signal power at
the FOMA terminal.
(0 : lowest - 75 : highest value)
ー
AT＊DRPW
＊DRPW : 0
OK
+++ Switch the FOMA terminal from
the on-line data mode to on-line
command mode.
This command is not
applicable to the connection
using packet
communication.
(Online Data Mode)
+++ (Unable to see the
display)
OK
AT+CBST
[&F] [&W]
[?] [=?]
Set the bearer (communication
type) service.
AT+CBST=<speed>,
<name>,<ce>
speed=116 : 64K data
communication.
speed=134 : Video calls 64K
name=1 : data circuit
synchronous.
ce=0 : transparent.
AT+CBST=11
6, 1, 0
AT+CEER Display the reason for
disconnection of the previous
connection.
“Reasons for Disconnection”
→P50
AT+CEER
+CEER : ●●
OK
AT+CGDCONT
[?] [=?]
Set APN when sending Packet
communication.
→P49 →P49
AT+CGEQMIN
[?] [=?]
Register criteria value for
determining if QoS (Quality of
Service) sent from network
when Packet communication is
established, is acceptable or
not.
AT+CGEQMIN=
[Parameters] →P49
→P49
AT+CGEQREQ
[?] [=?]
Set QoS (Quality of Service) to
request for the network when
Packet communication is
established.
AT+CGEQREQ=
[Parameters] →P49
→P49
AT+CGMR Display the version of the FOMA
terminal (16-digit number).
ー
AT+CGMR
1234512345
123456
OK
AT Command Overview Parameters/Description Command Examples
AT Command List