User's Manual

62
Utility Software
Network Settings
Network Settings
(Overseas Use)
• Insert the FOMA terminal into the PC card slot before
performing these steps.
• While the Communication Settings screen is displayed, no
operations can be performed from the Main screen. If a call
arrives during the operation, the call can be answered after
[閉じる (Close)] is clicked, however, the options being set
will be canceled.
Switching Networks Manually
Selecting and setting networks manually.
• Usually, set “通信方式選択 (Communication system)” to
“オート (Auto)”.
a
Click (各種設定 (Settings)) on the
Main screen (P54)y“ネットワーク設定
(Network Settings)”
b
Perform the following steps
Select Communication System
Select a communication system to connect to the network.
yPull down menuySelect an option from the followingy
[選択(Select)] (a)
• Enter the PIN1 code using the keyboard of the PC.
Selecting a Network
Select a network (carrier). No operations are available if “オート
(Auto)” is set for “通信方式設定 (Communication system)”.
yPull down menuySelect an option from the followingy
[Select] (b)
■ If no appropriate networks were found with
“Communication System”
Click [ネットワーク再検索 (Search again for a
Network)] on the Communication Setting screen.
• After the search, found networks will be displayed in
“Networks2*”.
*: The names of available networks appear.
• When using the FOMA terminal in Japan, set “通信方式
選択 (Select Communication Method)” to “オート
(Auto)”.
• Depending on the network or signal status, this option
may not be set.
• The set network is displayed on the Main screen.
Default
通信方式 (Communication System):
オート (Auto)
ネットワーク選択 (Select Network):
オート (Auto)
Communication Setting Screen
a
b
“オート (Auto)”
: You can connect to an available network automatically.
“ネットワーク選択 (Select Network)” cannot be performed.
“W-CDMA固定 (Static W-CDMA)”
: Connection to a W-CDMA network will be established.
“GSM固定 (Static GSM)”
: Connection to a GSM/GPRS network will be established.
“オート (automatic Selection)”
: Available networks specified in “通信方式設定
(Communication system)” will be searched automatically.
“ネットワーク１*/ネットワーク２* (Network 1*/
Network 2*)”
: Directly select a network found by clicking “オート (Auto)”
or [ネットワーク再検索 (Search again for a Network)].
*: The names of available networks appear.
Network Settings