motorola H790 Quick Start Guide
your headset Take a moment to familiarize yourself with your new Motorola H790 Headset.
charge it charge it Charge your headset before using it. The indicator light is red or yellow while the battery is charging. When the battery is fully charged, the indicator light turns green. Note: Headset is not functional while charging. Note: Your battery is designed to last the life of your product. It should only be removed by a recycling facility. Any attempt to remove or replace your battery will damage your headset.
pair & connect Once charged, let’s get your headset paired and connected to your Bluetooth phone(s). pair & connect pair & connect first phone 1 2 3 4 Turn off any Bluetooth devices previously paired with your headset. Turn on the Bluetooth feature on your phone. Put headset on your ear (see “wear it” on page 8 for help). Turn on your headset (see “turn on” on page 9 for help). The indicator light becomes steadily lit in blue and you hear “ready to pair”.
pair & connect 5 Follow voice prompts to connect your phone to your headset. Note: When prompted for the passkey, enter 0000. When your headset successfully pairs with your phone, you hear “pairing complete”. When connected, you hear “phone 1 connected” and see the indicator light rapidly flash in blue and purple. pair & connect second phone (optional) 1 2 4 Turn off first phone and any other Bluetooth devices previously paired with your headset.
pair & connect 3 4 5 Turn on the Bluetooth feature on your phone. Put headset on your ear. Turn on your headset. The indicator light becomes steadily lit in blue and you hear “ready to pair”. 6 Follow voice prompts to connect your phone to your headset. When your headset successfully pairs with your phone, you hear “pairing complete”. When connected, you hear “phone 1 connected” and see the indicator light rapidly flash in blue and purple.
pair & connect headset is connected to both phones. The last paired phone (your second phone) is now your primary phone (or “phone 1”) for voice dial functionality. test your connection 1 2 Place the headset on your ear. On one phone, dial the number you want to call and press Call/Send key. Repeat for the second phone. If your phones and headset are successfully connected, you hear ringing on the headset. For daily use, make sure your headset is turned on, and your phone’s Bluetooth feature is on.
put it on choose an earbud put it on To get the best headset performance, try out all the supplied ear cushions to get a good fit. choose an ear Your headset comes ready for the right ear.
put it on wear it Flex the ear hook and loop it over your ear. Tip: For optimal audio performance and comfort, be sure to position the ear cushion into your ear canal and point the headset microphone towards your mouth.
turn on & off turn on turn on & off Slide the Power switch to the on position (no red is shown under the switch).The indicator light flashes blue three times, then flashes in blue and purple (if connected with a device) or is steadily blue (if ready to be paired). Power Switch Indicator Light turn off Slide the Power switch to the off position (red is shown under switch). The indicator light flashes three times then turns off.
battery check Press and hold both Volume buttons while not on a call. battery check indicator light voice prompt talk time red “battery level is low” less than 1.5 hours yellow “battery level is medium” between 1.5 to 3.5 hours green “battery level is high” more than 3.5 hours To save battery power, turn off the headset when you don't use it for an extended time.
calls calls To... answer call Press the Call button. reject call Press and hold a Volume button until you hear an audio tone make a voice dial call Press the Call button and you hear an audio tone. redial last call Press and hold the Call button until you hear an audio tone. mute or unmute a call Press and hold both Volume buttons until you hear “mute on” or “mute off”. end a call Press the Call button. answer second incoming call Press the Call button.
calls To... reject second incoming call Press and hold a Volume button until you hear a tone. Tip: When connected to two phones, voice prompts help manage call functions such as voice dial, redial, and end call. Follow the voice prompts to execute a function on the desired phone. Note: Your headset supports both Handsfree and Headset Profiles. Accessing call functions depends upon which profile your phone supports. See the instructions that came with your phone.
status indicators indicator light (with charger plugged in) status indicators headset indicator headset status red charging (battery level less than 50% charge) yellow charging (battery level more than 50% charge) green charging complete 13
status indicators indicator light (with charger not plugged in) headset indicator headset status off power off three blue flashes powering on/off steady blue pairing/connect mode rapid blue/purple flashes connection successful quick blue flash incoming/outgoing call on phone 1 quick purple flash incoming/outgoing call on phone 2 slow blue pulse connected (on a call) 14
status indicators headset indicator headset status slow blue flash standby (connected to one phone) slow green flash standby (connected to two phones) slow red flash idle (not connected to a phone) slow purple pulse connected call muted steady red attempting to connect quick red flash low battery Note: After 1 minute on a call or 20 minutes of inactivity, the light stops flashing to conserve power, but the headset remains on.
tips & tricks enable/disable voice prompts tips & tricks With the headset turned on, press and hold either Volume button and Call button until you hear “voice prompts on” or “voice prompts off”. restore to factory settings Caution: This action erases all pairing information stored in your headset. To restore your headset to original factory settings, with the headset turned on, press and hold both Volume buttons and Call button for 10 seconds until the indicator light is steady blue.
problems? My headset will not enter pairing mode. Make sure that any devices previously paired with the headset are turned off. If the indicator light is flashing in blue, first turn off the other device, then turn the headset off and on. The indicator light becomes steadily lit in blue and you hear “ready to pair”. problems? My phone doesn't find my headset when searching. Make sure the indicator light on your headset is steadily lit in blue when your phone is searching for devices.
problems? reset the headset by pressing and holding the Call button and both Volume buttons until the indicator light is steadily lit in blue. Then follow pair & connect instructions on pages 3-6. My headset connected before, but now it's not working. Make sure the indicator light on your headset is steadily lit in blue when your phone is searching for devices. If not, press and hold the Call and both Volume buttons until you hear “ready to pair” and see the indicator light steadily lit in blue. Support.
Safety & General Information IMPORTANT INFORMATION ON SAFE AND EFFICIENT OPERATION. READ THIS INFORMATION BEFORE USING YOUR DEVICE. Safety Information Approved Accessories Use of accessories not approved by Motorola, including but not limited to batteries, antennas, and convertible covers, may cause your mobile device to exceed RF energy exposure guidelines and may void your mobile device’s warranty. For a list of approved Motorola accessories, visit our Web site at: www.motorola.
Use & Safety for Battery-Powered Accessories • Do not store or use your battery-powered accessory (such as a Bluetooth® headset or other device) in temperatures below -10°C (14°F) or above 60°C (140°F). • Do not recharge your accessory in temperatures below 0°C (32°F) or above 45°C (113°F). • Conditions inside a parked car can exceed this range. Do not store your accessory in a parked car. • Do not store your accessory in direct sunlight.
• Where possible, use your headset in a quiet environment with low background noise. • Avoid turning up the volume to block out noisy surroundings. • Turn the volume down if you can’t hear people speaking near you. If you experience hearing discomfort, including the sensation of pressure or fullness in your ears, ringing in your ears, or muffled speech, you should stop listening to the device through your headset or headphones and have your hearing checked by your doctor.
FCC Notice to Users The following statement applies to all products that have received FCC approval. Applicable products bear the FCC logo, and/or an FCC ID in the format FCC-ID:xxxxxx on the product label. Motorola has not approved any changes or modifications to this device by the user. Any changes or modifications could void the user’s authority to operate the equipment. See 47 CFR Sec. 15.21. This device complies with part 15 of the FCC Rules.
to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and the receiver. • Connect the equipment to an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help.
Products and Accessories Products Covered Products and Accessories as defined above, unless otherwise provided for below. Decorative Accessories and Cases. Decorative covers, bezels, PhoneWrap™ covers and cases. Monaural Headsets. Ear buds and boom headsets that transmit mono sound through a wired connection. Consumer and Professional Two-way Radio Accessories. Products and Accessories that are Repaired or Replaced.
Exclusions Normal wear and tear. Periodic maintenance, repair and replacement of parts due to normal wear and tear are excluded from coverage. Batteries. Only batteries whose fully charged capacity falls below 80% of their rated capacity and batteries that leak are covered by this limited warranty. Abuse & misuse. Defects or damage that result from: (a) improper operation, storage, misuse or abuse, accident or neglect, such as physical damage (cracks, scratches, etc.
Altered products. Products or Accessories with (a) serial numbers or date tags that have been removed, altered or obliterated; (b) broken seals or that show evidence of tampering; (c) mismatched board serial numbers; or (d) nonconforming or non-Motorola housings, or parts, are excluded from coverage. Communication services.
Software NOT embodied in physical media. Software that is not embodied in physical media (e.g. software that is downloaded from the Internet), is provided “as is” and without warranty. Who is Covered? This warranty extends only to the first consumer purchaser, and is not transferable. What Will Motorola Do? Motorola, at its option, will at no charge repair, replace or refund the purchase price of any Products, Accessories or Software that does not conform to this warranty.
How to Obtain Warranty Service or Other Information USA Phones: 1-800-331-6456 Pagers: 1-800-548-9954 Two-Way Radios and Messaging Devices: 1-800-353-2729 Canada All Products: 1-800-461-4575 TTY 1-888-390-6456 For Accessories and Software, please call the telephone number designated above for the product with which they are used. You will receive instructions on how to ship the Products, Accessories or Software, at your expense, to a Motorola Authorized Repair Center.
What Other Limitations Are There? ANY IMPLIED WARRANTIES, INCLUDING WITHOUT LIMITATION THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, SHALL BE LIMITED TO THE DURATION OF THIS LIMITED WARRANTY, OTHERWISE THE REPAIR, REPLACEMENT, OR REFUND AS PROVIDED UNDER THIS EXPRESS LIMITED WARRANTY IS THE EXCLUSIVE REMEDY OF THE CONSUMER, AND IS PROVIDED IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED.
Product Registration Online Product Registration: www.motorola.com/us/productregistration Product registration is an important step toward enjoying your new Motorola product. Registering permits us to contact you for product or software updates and allows you to subscribe to updates on new products or special promotions. Registration is not required for warranty coverage. Please retain your original dated sales receipt for your records.
Caring for the Environment by Recycling This symbol on a Motorola product means the product should not be disposed of with household waste. Recycling Information Disposal of your Mobile Device & Accessories Please do not dispose of mobile devices or electrical 032376o accessories (such as chargers, headsets, or batteries) with your household waste. Do not dispose of your battery or mobile device in a fire.
European Union Directives Conformance Statement Hereby, Motorola declares that this product is in compliance with: EU Conformance • The essential requirements and other relevant provisions of Directive 1999/5/EC • All other relevant EU Directives Product Approval Number The above gives an example of a typical Product Approval Number. You can view your product’s Declaration of Conformity (DoC) to Directive 1999/5/EC (to R&TTE Directive) at www.motorola.com/rtte.
Motorola, Inc. Consumer Advocacy Office 600 N. US Hwy 45 Libertyville, IL 60048 www.motorola.com Note: Do not ship your accessory product to the above address.
Software Copyright Notice The Motorola products described in this manual may include copyrighted Motorola and third-party software stored in semiconductor memories or other media. Laws in the United States and other countries preserve for Motorola and third-party software providers certain exclusive rights for copyrighted software, such as the exclusive rights to distribute or reproduce the copyrighted software.
