MOTOROLA FINITI™ Quick Start Guide
Congratulations Your MOTOROLA FINITI™ headset delivers the best sound in any condition and without raising your voice. CrystalTalk™ dual microphones are used for everyday noise cancellation, and the stealth mode for windy or extreme conditions. Some other cool features: • Hear and reply to phone text messages with MotoSpeak™. • Hear the caller’s name and use your voice to answer or ignore calls. • Stream Bluetooth® music from your phone.
matter of minutes we’ll show you just how easy your headset is to use. So go on, check it out. more information on the Web: www.motorola.com/support Caution: Before using your headset for the first time, please read the important Safety, Regulatory & Legal information at the back of this guide (page 25).
Your headset the important parts Call Button side view Ear Loop MicroUSB Charging Connector Power Switch Status Light Earhook Volume Buttons Earpiece with the Stealth the Stealth Mode Sensor Mode Button Warning: Do not apply pressure or squeeze the stealth mode sensor (small rubber balloon), as it can damage the parts inside and will void the warranty.
Charge it let’s get you up and running Status Light Red/Yellow - charging Green - fully charged While your headset is charging, you won’t be able to use it. Note: Your battery is designed to last the life of your product. It should only be removed by a recycling facility. Any attempt to remove or replace your battery will damage your headset.
Basics a few essentials to get you started Change ear fitting Your headset comes with multiple ear fittings. Left Ear Spring Right Ear Spring Large Ear Loop Medium Small Ear Ear Loop Loop Choose your ear fitting (loop or spring) so your headset is comfortable. 1 Lift the current ear fitting up and slide it off the headset in an upward direction.
2 Slide the new ear loop or spring downward onto the earpiece, then align and push the bottom onto the groove. Groove Wear it 1 Bend the ear loop or spring and insert the earpiece into your ear. the Stealth mode sensor Make sure Ear canal the stealth mode sensor is in contact with your ear canal.
2 Place the ear loop or spring in the bend of your ear. 3 Flex the earhook and loop it over your ear, and point the headset microphone towards your mouth.
Turn it on & off Power Switch On Off Listen to music Note: This feature is phone dependent. Your headset allows you to stream Bluetooth music from your phone. Music playback is started and controlled from your phone. While a call is active, music pauses. When the call ends, music resumes playing.
Enhanced call features Tell headset to answer or ignore calls Use your voice to answer or ignore an incoming call: • say “answer” to answer the call • say “ignore” to ignore the call Note: This feature does not work for second incoming calls. Hear caller’s name If your phone knows your caller’s name, then you hear “call from ” on an incoming call. Clean your headset Keep your headset clean and dry. High humidity or perspiration can make the ear fitting feel slippery.
wipe it with a soft cloth to remove dirt and moisture. Note: Be very careful when wiping near the stealth mode sensor. Also check for any debris that may be blocking the small speaker port on the ear fitting.
Pair & connect connect and go Pair & connect with your phone 1 Turn off any Bluetooth® devices previously paired with your headset. 2 Turn on the Bluetooth feature on your phone. 3 Put the headset on your ear (see “Wear it” on page 6). 4 Turn on your headset (see “Turn it on & off” on page 8). The status light becomes steadily lit in blue and you hear “ready to pair”. 5 Follow the voice prompts to connect your phone to your headset. Note: When prompted for the passkey, enter 0000.
When your headset successfully pairs with your phone, you hear “pairing complete”. For daily use, make sure your headset is turned on, and your phone’s Bluetooth feature is on. Your headset and phone connect automatically. Pair & connect a second phone 1 Turn off first phone and any other Bluetooth devices previously paired with your headset. 2 Turn your headset off. 3 Turn on the Bluetooth feature on your phone. 4 Put the headset on your ear. 5 Turn on your headset.
6 Follow the voice prompts to connect your phone to your headset. Note: When prompted for the passkey, enter 0000. When your headset successfully pairs with your phone, you hear “pairing complete”. To connect to both phones, turn on the first phone while the second phone is connected. When you hear “ connected”, your headset is connected to both phones. Test your call connection 1 Place the headset on your ear. 2 On your phone, dial a phone number and press the Call/Send key.
Be clear your voice, not all the noise Always be heard during calls with the CrystalTalk dual microphones and the stealth mode sensor: • CrystalTalk is always on to cancel out everyday background noise. • The stealth mode can be turned on when noise and wind get really bad to shut out all background noise. Turn on the stealth mode Press the Stealth Mode button and listen for the “stealth mode on” or “stealth mode off” prompt.
Note: Make sure the stealth mode sensor is placed correctly and is in contact with the ear canal (see page 6). It is normal for the sound of your voice to be less “natural” in the stealth mode.
Calls it’s good to talk Note: Some features are phone/network dependent. To... answer call reject call make a voice dial call redial last call mute or unmute a call 16 Say “answer” or press the Call button. Say “ignore” or press and hold a Volume button until you hear a tone. Press the Call button and you hear a tone. Press and hold the Call button until you hear a tone. Press both Volume buttons.
To... end a call answer second incoming call reject second incoming call turn on/off stealth mode Press the Call button. Press the Call button. Press and hold a Volume button until you hear a tone. Press the stealth mode button. Tip: When connected to two phones, follow the voice prompts to perform functions such as voice dial, redial, and end call on the desired phone.
Talk time check your chat time Press both Volume buttons while not on a call. if light shows... and/or you hear... your remaining talk time is... red “battery level is low” less than 1.5 hours yellow “battery level is medium” between 1.5 to 3.5 hours green “battery level is high” more than 3.5 hours To save battery power, turn off the headset when not using it.
Status light know your headset If light shows... your headset is...
If light shows... your headset is... slow green flash in standby (not on a call—connected to two phones) slow red flash idle (not connected to a phone) slow red pulse muting the call steady red trying to connect to your phone quick red flash in a low battery state Note: After 1 minute on a call or 20 minutes of inactivity, the light stops flashing to conserve power, but the headset remains on.
Settings make some changes Press and hold the Call button while turning on the headset to turn these features on/off: • Reset to factory default Caution: This action erases all pairing information stored in your headset. • Caller ID • Voice prompts • Multipoint (two phone) connections Follow the voice prompts to make changes to these settings.
Problems? we’ve got solutions My headset will not enter pairing mode. Make sure that any devices previously paired with the headset are turned off. If the status light is not steadily lit in blue, turn off both the other device and headset, wait 10 seconds, then turn headset back on. Wait for the status light to become steadily lit in blue, indicating the headset is now in pairing mode. My phone doesn't find my headset when searching.
My headset worked before but now it's not working. Make sure your phone is on and the Bluetooth feature is turned on in your phone. If the Bluetooth feature was turned off or was turned on only temporarily, you may need to restart the Bluetooth feature and pair your phone and headset again (see “Pair & connect” on page 11). The person you are talking to does not hear you. Try rotating the headset in your ear. Or, you can switch to another ear fitting to provide a better fit.
Support we’re here to help If you have questions or need assistance, contact us at 1-877-MOTOBLU, or visit us at www.motorola.com/Bluetoothsupport or www.motorola com/bluetoothconnect.
Safety, Regulatory & Legal Safety & General Information IMPORTANT INFORMATION ON SAFE AND EFFICIENT OPERATION. READ THIS INFORMATION BEFORE USING YOUR DEVICE. Safety Information Use & Safety for Battery-Powered Accessories • Do not store or use your battery-powered accessory (such as a Bluetooth® headset or other device) in temperatures below -10°C (14°F) or above 60°C (140°F). • Do not recharge your accessory in temperatures below 0°C (32°F) or above 45°C (113°F).
Approved Accessories Use of accessories not approved by Motorola, including but not limited to batteries, antennas, and convertible covers, may cause your mobile device to exceed RF energy exposure guidelines and may void your mobile device’s warranty. For a list of approved Motorola accessories, visit our Web site at: www.motorola.com Driving Precautions Responsible and safe driving is your primary responsibility when behind the wheel of a vehicle.
• Use a handsfree device if available or required by law in your area. • Enter destination information into a navigation device before driving. • Use voice activated features (such as voice dial) and speaking features (such as audible directions), if available. • Obey all local laws and regulations for the use of mobile devices and accessories in the vehicle. • End your call or other task if you cannot concentrate on driving. Responsible driving practices can be found at www.motorola.
If you experience hearing discomfort, including the sensation of pressure or fullness in your ears, ringing in your ears, or muffled speech, you should stop listening to the device through your headset or headphones and have your hearing checked. For more information about hearing, see our Web site at direct.motorola.com/hellomoto/nss/AcousticSafety.asp (in English only). Small Children Keep your mobile device and its accessories away from small children.
Symbol Key Your battery, charger, or mobile device may contain symbols, defined as follows: Symbol 032374o 032376o Definition Important safety information follows. Do not dispose of your battery or mobile device in a fire. Do not dispose of your battery or product with your household waste. See “Recycling” for more information. For indoor use only.
FCC Notice to Users The following statement applies to all products that have received FCC approval. Applicable products bear the FCC logo, and/or an FCC ID in the format FCC ID:xxxxxx on the product label. Motorola has not approved any changes or modifications to this device by the user. Any changes or modifications could void the user’s authority to operate the equipment. See 47 CFR Sec. 15.21. This device complies with part 15 of the FCC Rules.
to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and the receiver. • Connect the equipment to an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help.
• Keep software up to date—If Motorola or a software/ application vendor releases a patch or software fix for your product that updates the device’s security, install it as soon as possible. • Secure Personal Information—Your product can store personal information in various locations including a SIM card, memory card, and built-in memory. Be sure to remove or clear all personal information before you recycle, return, or give away your product.
Use & Care To care for your Motorola product, please keep it away from: Use & Care liquids of any kind Don’t expose your product to water, rain, extreme humidity, sweat, or other moisture. If it does get wet, don’t try to accelerate drying with the use of an oven or dryer, as this may damage the product. extreme heat or cold Avoid temperatures below -10°C (14°F) or above 60°C (140°F). microwaves Don’t try to dry your product in a microwave oven.
shock and vibration Don’t drop your product. Recycling Recycling Mobile Devices & Accessories Please do not dispose of mobile devices or electrical accessories (such as chargers, headsets, or batteries) with your household waste, or in a fire. These items should be disposed of in accordance with the national collection and recycling schemes operated by your local or regional authority.
Software Copyright Notice Motorola products may include copyrighted Motorola and third-party software stored in semiconductor memories or other media. Laws in the United States and other countries preserve for Motorola and third-party software providers certain exclusive rights for copyrighted software, such as the exclusive rights to distribute or reproduce the copyrighted software.
Product Registration Online Product Registration: www.motorola.com/us/productregistration Product registration is an important step toward enjoying your new Motorola product. Registering permits us to contact you for product or software updates and allows you to subscribe to updates on new products or special promotions. Registration is not required for warranty coverage. Please retain your original dated sales receipt for your records.
Motorola Limited Warranty for the United States and Canada Warranty What Does this Warranty Cover? Subject to the exclusions contained below, Motorola Mobility, Inc.
Products Covered Length of Coverage Decorative Accessories and Cases. Decorative covers, bezels, PhoneWrap™ covers and cases. Limited lifetime warranty for the lifetime of ownership by the first consumer purchaser of the product. Monaural Headsets. Ear buds and boom headsets that transmit mono sound through a wired connection. Limited lifetime warranty for the lifetime of ownership by the first consumer purchaser of the product. Products and Accessories that are Repaired or Replaced.
Abuse & Misuse. Defects or damage that result from: (a) improper operation, storage, misuse or abuse, accident or neglect, such as physical damage (cracks, scratches, etc.
signal you may subscribe to or use with the Products Accessories or Software is excluded from coverage. Software Products Covered Length of Coverage Software. Applies only to physical defects in the media that embodies the copy of the software (e.g. CD-ROM, or floppy disk). Ninety (90) days from the date of purchase. Exclusions (Software) Software Embodied in Physical Media.
Who is Covered? This warranty extends only to the first consumer purchaser, and is not transferable. What Will Motorola Do? Motorola, at its option, will at no charge repair, replace or refund the purchase price of any Products, Accessories or Software that does not conform to this warranty. We may use functionally equivalent reconditioned/refurbished/pre-owned or new Products, Accessories or parts.
How to Obtain Warranty Service or Other Information USA All Products, Accessories, and Software: 1-800-331-6456 Canada All Products: 1-800-461-4575 TTY 1-888-390-6456 You will receive instructions on how to ship the Products, Accessories or Software, at your expense, to a Motorola Authorized Repair Center.
LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED.
Copyright & Trademarks Motorola Mobility, Inc. Consumer Advocacy Office 600 N US Hwy 45 Libertyville, IL 60048 www.hellomoto.com Note: Do not ship your product to the above address.
MOTOROLA and the Stylized M Logo are trademarks or registered trademarks of Motorola Trademark Holdings, LLC. The Bluetooth trademarks are owned by their proprietor and used by Motorola Mobility, Inc. under license. All other product or service names are the property of their respective owners. © 2010 Motorola Mobility, Inc. All rights reserved. Caution: Changes or modifications made in the radio phone, not expressly approved by Motorola, will void the user’s authority to operate the equipment.
46
