User's Manual
11/15/00 68P80801D55-O
The following general safety precautions must be observed during all phases of operation, service, and repair of
the equipment described in this manual. The safety precautions listed below represent warnings of certain dangers
of which we are aware. You should follow these warnings and all other safety precautions necessary for the safe
operation of the equipment in your operating environment.
!
Read and follow all warning notices and instructions marked on the product or included in this manual beĆ
fore installing, servicing or operating the equipment. Retain these safety instructions for future reference.
Also, all applicable safety procedures, such as Occupational, Safety, and Health Administration (OSHA)
requirements, National Electrical Code (NEC) requirements, local code requirements, safe working practicĆ
es, and good judgement must be used by personnel.
Refer to appropriate section of the product service manual for additional pertinent safety information.
Because of danger of introducing additional hazards, do not install substitute parts or perform any unauthoĆ
rized modifications of equipment.
Identify maintenance actions that require two people to perform the repair. Two people are required when:
- A repair has the risk of injury that would require one person to perform first aid or call for emergency
support. An example would be work around high voltage sources. A second person may be required
to remove power and call for emergency aid if an accident occurs to the first person.
ą ! "
! "
If troubleshooting the equipment while power is applied, be aware of the live circuits.
DO NOT operate the transmitter of any radio unless all RF connectors are secure and all connectors are
properly terminated.
All equipment must be properly grounded in accordance with Motorola Standards and Guideline for ComĆ
munications Sites R56" 68P81089E50 and specified installation instructions for safe operation.
Slots and openings in the cabinet are provided for ventilation. To ensure reliable operation of the product
and to protect if from overheating, these slots and openings must not be blocked or covered.
Only a qualified technician familiar with similar electronic equipment should service equipment.
Some equipment components can become extremely hot during operation. Turn off all power to the equipĆ
ment and wait until sufficiently cool before touching.
This equipment is designed to generate and radiate radio frequency (RF) energy by means of an external antenna.
When terminated into a non-radiating RF load, the base station equipment is certified to comply with Federal ComĆ
munications Commission (FCC) regulations pertaining to human exposure to RF radiation in accordance with the
FCC Rules Part 1 section 1.1310 as published in title 47 code of federal regulations and procedures established
in TIA/EIA TSB92, Report On EME Evaluation for RF Cabinet Emissions Under FCC MPE Guidelines. Compliance
to FCC regulations of the final installation should be assessed and take into account site specific characteristics