User's Manual

9-2 MTR2000 MOTOTRBO Digital Upgrade: Unpacking
9.2 Unpacking
This section describes the procedures to unpack the new front bezel, new SCM module, new Exciter
and Receiver modules from the packaging prior to installing them.
9.2.1 Equipment Unpacking and Inspection
9.2.1.1 Introduction
The new front bezel, new Exciter module, new Receiver module and new SCM module may be
shipped by either air freight or electronic van (as specified by customer), except where noted.
Thoroughly inspect the equipment as soon as possible after delivery. If any part of the equipment is
damaged during transit, immediately report the extent of the damage to the transportation company
and to Motorola.
9.2.1.2 Unpacking Equipment
The new front bezel, new Exciter Module, new Receiver Module and new Station Control Module are
packed in four separate boxes which are packed together in a common box. The individual boxes
are cushioned between corrugated cardboard in a common box.
Note
Currently, the MTR2000 MOTOTRBO Digital Upgrade is limited to the high power (100W)
UHF BR. Additionally, once the upgrade is performed, the wireline and Auxiliary I/O board
functionality will no longer be supported.
To avoid damage to the parts, be sure to observe proper electrostatic
discharge precautions when modules are removed from the station.
Applicant: Motorola
Equipment Type: ABZ89FC4827
Exhibit D1-4