User's Manual

Chapter 12 MTR3000 Programming and Tuning
12.1 Introduction
This chapter provides an overview of the MOTOTRBO Customer Programming Software (CPS) for
the MTR3000 and MTR2000 MOTOTRBO Digital Upgrade, as well as the MOTOTRBO Tuner
application for use on Windows XP
TM
, Windows Vista Home Premium
TM
or Windows Vista Business
Edition
TM
32 bit and 64 bit operating system.
12.2 Customer Programming Software Setup
The Customer Programming Software setup, shown in Figure 12-1 is used to program the base
station/repeater. Refer to Figure 12-2 and Figure 12-3 for the actual connectors on the front and rear
panels of the base station/repeater.
Note
Refer to the appropriate program on-line help files for the programming procedures.
Note
Refer to the appropriate program on-line help files for the programming procedures.
Computer USB ports can be sensitive to Electronic Discharge. Employ
proper ESD practices (wrist strap, grounding, etc.) and do not touch
exposed contacts on cables when connected to a computer.
Figure 12-1. Customer Programming Software Setup from Rear Accessory Connector
Front Panel
USB
AC
USB
120 / 240 VAC
Station
Tx Port
(N-type Female)
Rx Port
(N-type Female)
AUX (J7)
DC
28 VDC
Either One or Both
Standard Type “A” to Type “B” USB cable
Rear Panel
Computer
Applicant: Motorola
Equipment Type: ABZ89FC4827
Exhibit D1-4