MN000350A02.
MN000350A02.
MN000350A02.book Page 1 Tuesday, December 2, 2014 3:01 PM APX Vehicular Adapter (VA) System Compatibility Matrix Table 1: APX Vehicular Adapter (VA) Compatible Radios Model Number Description APX6000 APX6000XE APX6000Li APX5000 P25 Portable Radio. Available in 700/800 MHz, VHF, UHF R1, and UHF R2 bands.
MN000350A02.book Page 2 Tuesday, December 2, 2014 3:01 PM Table 4: APX Vehicular Adapter (VA) Compatible Antennas Compatible Option/Kit Kit Number Description HAE4011 3.5 dB gain (450-470) HAE4012 3.5 dB gain (470 – 495) HAE4013 3.5 dB gain (494 – 512) HAE6010 3.
MN000350A02.book Page 3 Tuesday, December 2, 2014 3:01 PM ASTRO™ APX™ Vehicular Adapter (APX VA) RF Energy Exposure and Product Safety Before using this radio, read the information in this section which contains important operating instructions for safe usage and radio RF energy awareness and control information for compliance with RF energy exposure limits in applicable national and international standards.
MN000350A02.book Page 4 Tuesday, December 2, 2014 3:01 PM All Motorola two-way radios are designed, manufactured, and tested to ensure that they meet government-established RF exposure levels. In addition, manufacturers also recommend specific operating instructions to users of two-way radios. These instructions are important because they inform users about RF energy exposure and provide simple procedures on how to control it.
MN000350A02.book Page 5 Tuesday, December 2, 2014 3:01 PM • United States Federal Communications Commission (FCC), Code of Federal Regulations; 47 CFR et seq. • FCC, OET Bulletin 65. • Institute of Electrical and Electronic Engineers (IEEE) C95.1. • International Commission on Non-Ionizing Radiation Protection (ICNIRP). • Ministry of Health (Canada) Safety Code 6. • Industry Canada RSS-102, Australian Communications Authority Radiocommunications Standard et seq.
MN000350A02.book Page 6 Tuesday, December 2, 2014 3:01 PM Note: Table 1 below lists the recommended lateral distance for people in an uncontrolled environment from the body of a vehicle with an approved, properly installed transmitting antenna (such as monopoles over a ground plane, or dipoles). Table 1: Recommended Minimum Lateral Distance from Vehicle Body of Vehicle-Installed Mobile Two-Way Radio Minimum Lateral Distance from Vehicle Body 3 ft.
MN000350A02.book Page 7 Tuesday, December 2, 2014 3:01 PM • For a list of Motorola-approved antennas and other accessories, visit the following web site which lists the approved accessories for the APX VA or refer to “APX Vehicular Adapter (VA) System Compatibility Matrix” on page 1. http://www.motorolasolutions.com Additional Information For additional information on exposure requirements or other training information, visit: http://responsibility.motorolasolutions.com/index.
MN000350A02.book Page 8 Tuesday, December 2, 2014 3:01 PM Compliance and Control Guidelines and Operating Instructions for Mobile Two-Way Radios Installed on Maritime Vessels If mobile radio equipment is installed on a vessel and operated as a fixed unit, the antenna installation must comply with the following requirements in order to ensure optimal performance and compliance with RF energy exposure limits in the standards and guidelines listed on page 3.
MN000350A02.book Page 9 Tuesday, December 2, 2014 3:01 PM Vehicles To avoid possible interaction between the radio transmitter and any vehicle electronic control modules, such as ABS, engine, or transmission controls, the radio should be installed only by an experienced installer and the following precautions should be used when installing the radio. 1. Refer to the manufacturer’s instructions or other technical bulletins for recommendations on radio installation. 2.
MN000350A02.book Page 10 Tuesday, December 2, 2014 3:01 PM If you experience hearing discomfort, ringing in your ears, or muffled speech, you should stop listening to your radio through your headset or earpiece, and have your hearing checked by your doctor. Operational Warnings ! For Vehicles with an Air Bag Do not mount or place a mobile radio in the area over an air bag or in the air bag deployment area. Air bags inflate with great force.
MN000350A02.book Page 11 Tuesday, December 2, 2014 3:01 PM Installation Instructions Introduction This publication describes the installation procedure for the ASTRO APX6000 Vehicular Adapter (APX VA), used ONLY with APX6000 series radios, and basic user guide instructions. Complete installation, user guide, and troubleshooting details are explained in publication part number MN000350A01 located at Motorola Solutions Online. https://businessonline.motorolasolutions.
MN000350A02.book Page 12 Tuesday, December 2, 2014 3:01 PM Installation Planning The Motorola ASTRO™ APX™ Vehicular Adapter (APX VA) is an accessory designed to adapt APX6000 series portable radios for vehicular operation and battery charging.
MN000350A02.book Page 13 Tuesday, December 2, 2014 3:01 PM • Do not attach the unit to any part of the vehicle that is not rigid or is subject to excessive vibration. • Do not install unit in areas where rain or snow can easily get into them, such as next to a vehicle window which may be left open. • Do not dress cables over sharp edges that could cause wear or tearing of cable insulation.
MN000350A02.book Page 14 Tuesday, December 2, 2014 3:01 PM When possible, mount the console on the floor near the center of the vehicle within easy reach of the operator. • Do not reuse trunnion (“U”) bracket hardware (screws) from a legacy product. • Do use the trunnion (“U”) bracket hardware (screws) provided with the APX VA kit. Microphone Bracket Location When possible, mount the microphone bracket on the dash near the operator side of the console.
MN000350A02.book Page 15 Tuesday, December 2, 2014 3:01 PM Optional Speaker Location Select a location for the speaker that will neither be dangerous to the operator nor damaging to the speaker. A trunnion bracket is provided for mounting the speaker. The speaker is normally hung under the dash near the right side of the console, however, the trunnion bracket permits mounting the speaker against a wall or other vertical surface, if desired.
MN000350A02.book Page 16 Tuesday, December 2, 2014 3:01 PM 3. Insert the Allen-screws provided through the trunnion bracket and screw them into the console. Since the console may have to be removed later to connect the cables, do not tighten the screws at this time. 0.125” (0.3175 cm) Dia. Holes Cut-Away of Dash Trunnion Bracket (Optional) 1 2 Plastic Guides Groove Dash Mount Console or Floor Mount 1 2 Trunnion Bracket (Optional) Legend: 1. No.
MN000350A02.book Page 17 Tuesday, December 2, 2014 3:01 PM M5 x 18mm Mounting Bracket Hardware Note: Use only the M5 x 18mm screws supplied with the unit.
MN000350A02.book Page 18 Tuesday, December 2, 2014 3:01 PM If these conditions cannot be satisfied, then mount the antenna on the roof top. Mounting restrictions for certain radio models: a. For all VHF and UHF models, the 1/4 wave antenna should be mounted only in the center area of the roof, not on the trunk lid, to ensure compliance with RF Energy Safety Standards. b. Ensure that the antenna cable can be easily routed to the APX VA.
MN000350A02.book Page 19 Tuesday, December 2, 2014 3:01 PM Note: Applying excessive force with a tool can cause damage to the antenna or the connector (such as stripping threads, deforming the collar or connector, or causing the connector to twist in the housing opening and break). The mini-UHF connector tool (part number HLN6695) is designed to securely tighten the antenna plug-APX VA jack connection without damaging either the plug or the jack.
MN000350A02.book Page 20 Tuesday, December 2, 2014 3:01 PM Console Cabling Refer to Figure 5 and Figure 6 before routing or connecting any console cable. The console should be cabled using the following procedure: • This product is designed for a 12-volt, negative-ground system. • Remove the 5-amp fuses from the power cable (red and yellow wires) before proceeding. Note: 1.
MN000350A02.book Page 21 Tuesday, December 2, 2014 3:01 PM VEHICLE CHASSIS RED 13.8 VOLT VEHICLE BATTERY 5-AMP BLADE-TYPE FUSE GROMMET FIREWALL A+ FUSE BOX OR SWITCHED A+ VEHICLE ANTENNA YELLOW 5-AMP BLADE-TYPE FUSE BLACK OPTIONAL SPEAKER MOBILE MICROPHONE Figure 6: Console Cabling Important Note: Failure to mount the red lead of the power cable kit directly to the battery may result in severe alternator whine interference.
MN000350A02.book Page 22 Tuesday, December 2, 2014 3:01 PM Condition Battery Charging Standard Wiring Optional Wiring Vehicle = ON Vehicle = OFF* Vehicle = ON or OFF Yes No Yes Vehicle Battery Drain Radio OUT 20 mA 2.5 mA 20 mA Radio IN but OFF 30 – 900 mA 11 mA 30 – 900 mA Radio In and ON** 125 – 2000 mA 30 – 1000 mA 125 – 2000 mA *After vehicle has been off for 30 minutes (Note: Standard Wiring Configuration).
MN000350A02.book Page 23 Tuesday, December 2, 2014 3:01 PM LED Surveillance Configuration (Option Wiring – User Configurable) The APX VA’s LED indicator can be disabled for night use or surveillance operations by using the optional wiring connections below (refer to the Speaker and Interface Connector (J1) from Figure 5 and Figure 7.
MN000350A02.book Page 24 Tuesday, December 2, 2014 3:01 PM Installation Verification After completing the installation of the vehicular adapter, check all electrical wiring for tight connections. Also, check all mechanical parts and wiring for tight and secure mounting. Check for proper operation of the console, microphone, speaker, and radio as described in the User Guide, Motorola Solutions publication MN000350A01-AA.
MN000350A02.book Page 25 Tuesday, December 2, 2014 3:01 PM Operational Warnings ! Vehicles With an Air Bag Do not place a portable radio or install radio communications equipment in the area over an air bag or in the air bag deployment area. Air bags inflate with great force. If a portable radio is placed in the air bag deployment area and the air bag inflates, the radio may be propelled with great force and cause serious injury to occupants of the vehicle.
MN000350A02.book Page 26 Tuesday, December 2, 2014 3:01 PM Operational Warnings (continued) ! Blasting Caps and Blasting Areas To avoid possible interference with blasting operations, turn your radio off and eject it from the APX VA when you are near electrical blasting caps, in a blasting area, or in areas posted “Turn off two-way radio.” Obey all signs and instructions.
MN000350A02.book Page 27 Tuesday, December 2, 2014 3:01 PM Efficient System Operation • Do not operate your APX VA unless all RF connectors are properly terminated. • All equipment must be properly grounded according to Motorola’s installation instructions for safe operation. All equipment should be serviced only by an authorized technician.
MN000350A02.book Page 28 Tuesday, December 2, 2014 3:01 PM Keep foreign objects from falling into the APX VA. Trying to retrieve items that have accidentally fallen into the APX VA is not recommended. Consult a service technician for maintenance. Retrieve radio and disconnect VA until serviced. In some installations, the ignition switch is bypassed so that the APX VA charges the radio battery with the ignition switch turned off.
MN000350A02.book Page 29 Tuesday, December 2, 2014 3:01 PM Figure 8: Radio with Keypad Orientation and Speaker Orientation (respectively) Note: Ensure radio is fully seated to bottom of pocket for proper orientation. Figure 9: Radio Installation into APX VA Unit Lock Engage button Disengage Button LED Status Indicator Figure 10: APX VA Mechanisms for Radio Installation/Extraction Note: 1. Do not push on the purple disengage button during radio insertion.
MN000350A02.book Page 30 Tuesday, December 2, 2014 3:01 PM 2. Avoid running the starter motor while turning the radio on or inserting it into the APX VA as this can provide a False LED Indication (light solid purple). To clear, refer to the Troubleshooting Guide in the online manual, part number MN000350A01. 3. The radio must be turned on to operate with the APX VA. It may be turned on before or after it is loaded into the APX VA. 4. If the key is horizontal, radio is unlocked.
MN000350A02.book Page 31 Tuesday, December 2, 2014 3:01 PM Note: 1. A portable radio battery may not quickly recharge in the APX VA if the battery is very hot or cold. To maximize battery life, and to avoid charger LED indication flashing AMBER (rapid-charging paused), avoid leaving your radio in a very hot or cold vehicle. 2. The unit has a label, which explains the LED indications.
MN000350A02.book Page 32 Tuesday, December 2, 2014 3:01 PM While the battery is charging, the charging LED indicator will be illuminated Solid RED. When battery charging is complete, the charging LED will switch from Solid RED to Flashing GREEN to Solid GREEN, indicating that charging is complete. If the charge indicator is not on, the battery is not being charged.
MN000350A02.
MN000350A02.book Page 2 Tuesday, December 2, 2014 3:01 PM MOTOROLA, MOTO, MOTOROLA SOLUTIONS and the Stylized M logo are trademarks or registered trademarks of Motorola Trademark Holdings, LLC and are used under license. All other trademarks are the property of their respective owners. © 2014 Motorola Solutions, Inc. All rights reserved.
