User's Guide
Table Of Contents
- Introduction
- FCC Licensing Information
- Interference Information
- RF Energy Exposure Awareness and Control Information and Operational Instructions for Occupational Use
- Federal Communication Commission (FCC) Regulations
- Compliance with RF Exposure Standards
- RF Exposure Compliance and Control Guidelines and Operating Instructions for Two-Way Radio Operations
- Electromagnetic Interference/Compatibility
- Use of Communication Devices While Driving
- Acoustic Safety
- Operational Warnings
- Operational Warnings (Continued)
- Operational Cautions
- Hazard Locations (Intrinsically) Safe Radio Information
- Operational Cautions for Intrinsic Safe Equipment
- Warnings for Radios Approved as Intrinsically Safe
- Repair
- Radio Controls
- Getting Started
- Installing the Swivel Belt Holster
- Installing the Batteries
- Charging the Battery
- Turning Your Radio On and Off
- Adjusting the Volume
- Reading the Display
- Talking and Receiving
- Basic Radio Operation
- Signal Strength and Channel Busy Indicators
- Talk Range
- Handsfree Use (VOX) (CLS1410 only)
- Locking the Keypad
- Monitoring a Channel
- Scanning (CLS1410 Only)
- Programming Mode
- Factory Default Settings
- Entering Programming Mode
- Cloning Radio Settings
- Advanced Features
- Troubleshooting
- Use and Care
- Frequencies and Bandwidths
- Spirit GT Series Programming
- Limited Warranty for Motorola Personal Communications Products Purchased in the United States and Canada
- Warranty
- I. What This Warranty Covers
- II. What the Period of Coverage Is
- III. Who is Covered
- IV. What We Will Do to Correct Warranty Problems
- V. How to Obtain Warranty Service or Other Information
- VI. What This Warranty Does Not Cover
- VII. Some Other Limitations
- VIII. Patent and Software Provisions
- _Series Programming Quick Reference
Getting Started
22
Using the 56531 Multi-Unit Charger
The Multi-Unit Charger (MUC) allows drop-in charging of up to 6 radios or batteries.
Batteries can be charged inside the radios or removed and placed in the MUC
separately. Each of the 6 charging pockets can hold a radio or battery, but not both.
1. Place the charger on a flat surface.
2. Insert the power cord plug into the jack on the MUC.
3. Plug the cord into an AC outlet.
4. Turn the radio off.
5. Insert the radio or battery into the charging pocket.
Radio charging pocket
Battery charging pocket