User Manual
Table Of Contents
- Contents
- List of Figures
- List of Tables
- Copyrights
- General Information
- Getting Started
- Product Technical Information
- Before Power On
- Controls and Indicators
- Display
- Status Icons
- Powering On the Radio
- Unlocking Your Radio
- Locking/Unlocking the Keys/Buttons
- Holding Your Radio
- Entering TMO / DMO Mode
- Transmit Inhibit Mode
- Selecting Talkgroups
- Talkgroup Icon Selection
- Activating Talkgroup Scanning
- Broadcast Call
- Ambience Listening (AL) Call
- One-Touch Button Feature
- Terminal Temporary Disable/Enable
- Terminal Permanent Disable
- High/Low Audio Toggle
- During the Call
- Writing Text
- Home Display Text Message
- Modes
- Using Networks
- Trunked Mode Operation
- Entering TMO Mode
- Selecting Talkgroups
- Making Group Calls in TMO
- Receiving Group Calls in Idle
- Receiving Group Calls during Ongoing Group Calls
- Dynamic Group Number Assignment (DGNA)
- DGNA Reception
- DGNA Auto Select Group
- DGNA Auto Reselect Group
- Viewing DGNA Talkgroups
- Broadcast Calls Initiated by Users
- Initializing Broadcast Calls
- Phone and PABX Calls
- Private Call
- Making Private Calls
- Assistance Call
- Call Modification
- Local Site Trunking
- Direct Mode Operation
- Transmit Inhibit Mode
- Emergency Operations
- Emergency Group Call
- Making Emergency Group Calls
- Receiving Emergency Group Calls
- Non-Tactical Emergency
- Emergency Individual Calls (Private or MS-ISDN)
- Emergency Alarm
- Emergency SDS Status
- Emergency Hot Microphone
- Alternating Hot Microphone
- Silent Emergency Mode
- Invisible Emergency
- Disaster Alert
- Initializing Disaster Alert Calls
- Exiting Emergency Operations
- Repeater Mode
- GPS Location Service
- Main Menu
- Scrolling through the Menu
- Menu Icons
- Messages
- Contacts
- Bluetooth
- Browser
- Security
- Setup
- Group Setup
- Favorites
- My Info
- Recent Calls
- Shortcuts
- Networks
- Location
- Packet Data
- Crypto Menu
- Features
- Private Call
- Radio Messaging System (RMS)
- One-Touch Dial
- Talkgroup Dialing by Index
- Phone and PABX Calls
- Phone/PABX Speed Dial
- MS-ISDN
- Short Number Dial
- RUA/RUI
- WAP
- Call-Out
- Appendix A: Tones
- Appendix B: LED Indications
- Appendix C: Troubleshooting
- Appendix D: Maintenance
Crypto Menu
This sub-menu allows you to manage SIM card based End-to-End Encryption.
The End-to-End Encryption is used for:
• Encryption of voice transmission in the DMO and TMO Modes.
• Encryption of messages transmission in the TMO Mode.
• Encryption of messages transmission in the DMO Mode (the radio cannot be in call).
• Encryption of position data (GPS) transmission in the TMO and DMO Modes.
• Transfer of Operational Tactical Address (OPTA) in the TMO and DMO Modes.
• Management of encryption keys in the TMO Mode.
Setting Clear Call Alarm
When and where to use: Use this menu item to configure an alarm tone notifying about any clear
transmission.
Procedure:
1 From the home screen, press the MENU key.
2 Select Crypto Menu → Clear Call Alarm.
3 Select Simplex Calls or Duplex Calls.
4 Select one of the following:
• Off – the alarm is disabled.
• Single – the alarm sounds once at the beginning of a clear call.
• Continuous – the alarm sounds periodically throughout a clear call.
Updating Encryption Keys
When and where to use: Use this menu item to update old or incorrect encryption keys.
Procedure:
1 From the home screen, press the MENU key.
2 Select Crypto Menu → Upd Encr Keys.
3 Select Upd Group Key to start the update.
NOTICE:
You can update the encryption keys if the End-to-End Encryption is enabled. The keys cannot
be updated when the radio is in a call or in DMO.
Viewing OPTA
When and where to use: Use this menu item to view Operational Tactical Address (OPTA) providing
supplementary information about a subscriber's organization and operational role.
Procedure:
1 From the home screen, press the MENU key.
2 Select Crypto Menu → Show OPTA.
Chapter 5: Main Menu
Send Feedback 113