User's Manual
Table Of Contents
- COMPUTER SOFTWARE COPYRIGHTS
- Notational Conventions
- Welcome
- What is the HC700-L Handheld Computer?
- Unpacking
- HC700-L Features
- Charging the Battery
- Figure 3. HC700-L Personal Desktop Cradle
- Battery Replacement
- Figure 4. Battery Replacement
- 1. Hold down the Power Button for at least four seconds until the HC700-L screen turns off.
- 2. Remove the HC700-L hand-strap (see Figure 4).
- 3. Press the battery snap on the battery (see Figure 4) and pull away the battery from the HC700-L.
- 4. Insert a fresh battery, bottom end first, into the battery compartment.
- 5. Carefully, press the battery top downward until it clicks and locks in place.
- 6. Press the Power Button - the HC700-L is now ready for use.
- First Time Battery Charge
- Routine Battery Charge
- Battery Maintenance
- Battery Disposal
- To Prevent Injury or Burns
- Using the HC700-L
- Starting to Work
- Turning On
- Turning Off
- Suspend Mode
- The Status LED
- The Application LED
- Using the Keypad
- Direct Action Keys
- Scanning Barcodes and Capturing Images
- Figure 8. Capturing Images with the HC700-L Imager
- 1. Run the Bcr barcode reader application: Start Menu- >Programs->Sample Applications->Bcr.
- 2. Aim and hold the HC700-L at 2 to 12 inches (5 to 30 cm) distance from the target.
- 3. Press one of the Scan keys and aim the green aiming bar towards the target to adjust your posi...
- Resetting the HC700-L
- Mini SD Memory Card
- Service
- ActiveSync (USB) Connectivity
- Troubleshooting
2
via Microsoft ActiveSync
®
) or a dial-up modem. Ethernet con-
nection can be established through 10/100 base T interface
via multi-slot communication cradles. The HC700-L can also
communicate through a built-in IrDA port.
The HC700-L is equipped with a QVGA 3.5 inch transflective
TFT display, built to withstand high impact. Display backlight
is designed to enable clear screen visibility under varied light
conditions.
A touch-screen enables easy on-screen menu navigation, in
addition to using keypad navigation. The keypad uses an
adjustable backlight illumination, designed for low-light
working conditions.
The HC700-L is powered by an 1800 mAh 7.2V Lithium-Ion
battery pack. The battery is fully recharged within four hours
when the HC700-L is docked in a cradle.
A drained battery can be replaced without data loss from the
HC700-L memory ("hot swap"). A built-in power source, inde-
pendent of the battery pack, maintains the data in the HC700-
L memory for at least 5 minutes until a fresh battery is
placed.
The HC700-L may use a line of Motorola docking cradles for
network communications and power charging.
The personal desktop cradle is designed for office use of the
HC700-L. The eight and four slot charging/communication
cradles provide multi-slot docking in large operations. The
vehicle cradle is used for the mobile applications of the
HC700-L, allowing charging while driving.
For detailed description, installation and operation of each
cradle, refer to the specific user manual of each cradle.
Unpacking
The HC700-L basic package includes the following items:
• 1800 mAh 7.2V Lithium-Ion battery pack
•Stylus
• Hand-strap
Enhanced IMD Users.book Page 2 Monday, October 23, 2006 1:48 PM