User's Manual
Table Of Contents
- COMPUTER SOFTWARE COPYRIGHTS
- Notational Conventions
- Welcome
- What is the HC700-L Handheld Computer?
- Unpacking
- HC700-L Features
- Charging the Battery
- Figure 3. HC700-L Personal Desktop Cradle
- Battery Replacement
- Figure 4. Battery Replacement
- 1. Hold down the Power Button for at least four seconds until the HC700-L screen turns off.
- 2. Remove the HC700-L hand-strap (see Figure 4).
- 3. Press the battery snap on the battery (see Figure 4) and pull away the battery from the HC700-L.
- 4. Insert a fresh battery, bottom end first, into the battery compartment.
- 5. Carefully, press the battery top downward until it clicks and locks in place.
- 6. Press the Power Button - the HC700-L is now ready for use.
- First Time Battery Charge
- Routine Battery Charge
- Battery Maintenance
- Battery Disposal
- To Prevent Injury or Burns
- Using the HC700-L
- Starting to Work
- Turning On
- Turning Off
- Suspend Mode
- The Status LED
- The Application LED
- Using the Keypad
- Direct Action Keys
- Scanning Barcodes and Capturing Images
- Figure 8. Capturing Images with the HC700-L Imager
- 1. Run the Bcr barcode reader application: Start Menu- >Programs->Sample Applications->Bcr.
- 2. Aim and hold the HC700-L at 2 to 12 inches (5 to 30 cm) distance from the target.
- 3. Press one of the Scan keys and aim the green aiming bar towards the target to adjust your posi...
- Resetting the HC700-L
- Mini SD Memory Card
- Service
- ActiveSync (USB) Connectivity
- Troubleshooting
12
LED indications when HC700-L is used out of
the cradle
LED Indications when HC700-L is docked in
the cradle
Table 1: Status LED Indications When HC700-L is used out of the Cradle
LED Indication Description
Slowly flashing green HC700-L is in Suspend mode
Fast flashing green HC700-L display is off
Steady red for 5 sec-
onds
HC700-L is booting-up following battery
replacement
Important!: to avoid system failure, do
not remove the battery during boot-up
Flashing yellow Low battery voltage or battery tempera-
ture or is out of range
Table 2: Status LED Indications When HC700-L is docked in the Cradle
LED Indication Description
Steady red Battery is charging
Steady green Battery is fully charged
Flashing yellow Battery temperature or voltage is out
of range - battery charging has
stopped. Charging will resume when
temperature or voltage is back within
range
Flashing red Charging error/defective battery. Re-
install the HC700-L in the cradle
If the LED continues to flash red,
replace the battery
Steady orange HC700-L is communicating with host
Enhanced IMD Users.book Page 12 Monday, October 23, 2006 1:48 PM