User's Manual
Table Of Contents
- COMPUTER SOFTWARE COPYRIGHTS
- Notational Conventions
- Welcome
- What is the HC700-L Handheld Computer?
- Unpacking
- HC700-L Features
- Charging the Battery
- Figure 3. HC700-L Personal Desktop Cradle
- Battery Replacement
- Figure 4. Battery Replacement
- 1. Hold down the Power Button for at least four seconds until the HC700-L screen turns off.
- 2. Remove the HC700-L hand-strap (see Figure 4).
- 3. Press the battery snap on the battery (see Figure 4) and pull away the battery from the HC700-L.
- 4. Insert a fresh battery, bottom end first, into the battery compartment.
- 5. Carefully, press the battery top downward until it clicks and locks in place.
- 6. Press the Power Button - the HC700-L is now ready for use.
- First Time Battery Charge
- Routine Battery Charge
- Battery Maintenance
- Battery Disposal
- To Prevent Injury or Burns
- Using the HC700-L
- Starting to Work
- Turning On
- Turning Off
- Suspend Mode
- The Status LED
- The Application LED
- Using the Keypad
- Direct Action Keys
- Scanning Barcodes and Capturing Images
- Figure 8. Capturing Images with the HC700-L Imager
- 1. Run the Bcr barcode reader application: Start Menu- >Programs->Sample Applications->Bcr.
- 2. Aim and hold the HC700-L at 2 to 12 inches (5 to 30 cm) distance from the target.
- 3. Press one of the Scan keys and aim the green aiming bar towards the target to adjust your posi...
- Resetting the HC700-L
- Mini SD Memory Card
- Service
- ActiveSync (USB) Connectivity
- Troubleshooting
13
The Application LED
The Application LED may be used for any kind of application
notification. For example; the LED may show communication
indication when the application establishes connection with
a host computer or indicate an alert that needs to be handled.
For more information, refer to your software application
guide and the HC700 Software Development Kit (SDK).
Enhanced IMD Users.book Page 13 Monday, October 23, 2006 1:48 PM