User's Manual
Table Of Contents
- COMPUTER SOFTWARE COPYRIGHTS
- Notational Conventions
- Welcome
- What is the HC700-L Handheld Computer?
- Unpacking
- HC700-L Features
- Charging the Battery
- Figure 3. HC700-L Personal Desktop Cradle
- Battery Replacement
- Figure 4. Battery Replacement
- 1. Hold down the Power Button for at least four seconds until the HC700-L screen turns off.
- 2. Remove the HC700-L hand-strap (see Figure 4).
- 3. Press the battery snap on the battery (see Figure 4) and pull away the battery from the HC700-L.
- 4. Insert a fresh battery, bottom end first, into the battery compartment.
- 5. Carefully, press the battery top downward until it clicks and locks in place.
- 6. Press the Power Button - the HC700-L is now ready for use.
- First Time Battery Charge
- Routine Battery Charge
- Battery Maintenance
- Battery Disposal
- To Prevent Injury or Burns
- Using the HC700-L
- Starting to Work
- Turning On
- Turning Off
- Suspend Mode
- The Status LED
- The Application LED
- Using the Keypad
- Direct Action Keys
- Scanning Barcodes and Capturing Images
- Figure 8. Capturing Images with the HC700-L Imager
- 1. Run the Bcr barcode reader application: Start Menu- >Programs->Sample Applications->Bcr.
- 2. Aim and hold the HC700-L at 2 to 12 inches (5 to 30 cm) distance from the target.
- 3. Press one of the Scan keys and aim the green aiming bar towards the target to adjust your posi...
- Resetting the HC700-L
- Mini SD Memory Card
- Service
- ActiveSync (USB) Connectivity
- Troubleshooting
20
Resetting the HC700-L
You may need to reset the HC700-L; for example, you may
need to reset due to communication cut-off, or if the operat-
ing system or the application stops responding.
If the HC700-L stops responding, perform the following steps:
Step 1: Warm Reset
Important Note: When
the HC700-L performs
Warm Reset, all recorded
information remains
stored in memory.
Hold down the <ESC>
and <A> and <F> keys
(see Figure 10) for at least
5 seconds - the Motorola
logo will show on the
screen for about 30 sec-
onds and then Windows desktop or application screen will
appear - the HC700-L functions again.
If the HC700-L still does
not respond, perform
“Step 2: Cold Reset”:
Step 2: Cold Reset
Cold Reset restarts the
HC700-L by erasing all
stored records and
entries.
Do Not perform Cold
Reset unless Warm
Reset fails to solve the
problem.
Hold down the Power Button and <S> and <X> keys for at
least 5 seconds (see Figure 11); the HC700-L will restart its
operating system.
F
igure 10. Warm Reset-Key Combination
Figure 11. Cold Reset - Key Combination
Enhanced IMD Users.book Page 20 Monday, October 23, 2006 1:48 PM