User's Manual
Table Of Contents
- COMPUTER SOFTWARE COPYRIGHTS
- Notational Conventions
- Welcome
- What is the HC700-L Handheld Computer?
- Unpacking
- HC700-L Features
- Charging the Battery
- Figure 3. HC700-L Personal Desktop Cradle
- Battery Replacement
- Figure 4. Battery Replacement
- 1. Hold down the Power Button for at least four seconds until the HC700-L screen turns off.
- 2. Remove the HC700-L hand-strap (see Figure 4).
- 3. Press the battery snap on the battery (see Figure 4) and pull away the battery from the HC700-L.
- 4. Insert a fresh battery, bottom end first, into the battery compartment.
- 5. Carefully, press the battery top downward until it clicks and locks in place.
- 6. Press the Power Button - the HC700-L is now ready for use.
- First Time Battery Charge
- Routine Battery Charge
- Battery Maintenance
- Battery Disposal
- To Prevent Injury or Burns
- Using the HC700-L
- Starting to Work
- Turning On
- Turning Off
- Suspend Mode
- The Status LED
- The Application LED
- Using the Keypad
- Direct Action Keys
- Scanning Barcodes and Capturing Images
- Figure 8. Capturing Images with the HC700-L Imager
- 1. Run the Bcr barcode reader application: Start Menu- >Programs->Sample Applications->Bcr.
- 2. Aim and hold the HC700-L at 2 to 12 inches (5 to 30 cm) distance from the target.
- 3. Press one of the Scan keys and aim the green aiming bar towards the target to adjust your posi...
- Resetting the HC700-L
- Mini SD Memory Card
- Service
- ActiveSync (USB) Connectivity
- Troubleshooting
24
Battery does
not charge in
HC700-L Cra-
dle
HC700-L is not
locked in the
HC700-L Cradle
Re-install the HC700-L in
the HC700-L Cradle. Place
the HC700-L properly in
HC700-L Cradle. (Verify that
the HC700-L Cradle LED is
On and charge for three
hours)
HC700-L Cra-
dle contacts are
not clean
Clean contacts and remove
dust and objects from
within the HC700-L Cradle
Battery temper-
ature is out of
range (Status
LED flashes yel-
low)
Ensure that the battery
temperature is within
range. (refer to “Charging
the Battery” on page 6). If
battery remains hot,
replace battery (defective
battery).
Defective bat-
tery
Replace battery
HC700-L
does not
detect scan
input
Aiming pattern
not directed at
the barcode
symbol
Scan again and make sure
that the green light is
aimed across the barcode
Check for readable barcode
(not covered, or abstracted)
Unreadable
barcode
Be sure the barcode symbol
is not covered, damaged or
obstructed. Make sure the
barcode symbology is con-
figured. For a list of symbol-
ogies configured by default,
refer to the Specifications
section.
Table 4: Troubleshooting the HC700-L
Problem Cause Solution
Enhanced IMD Users.book Page 24 Monday, October 23, 2006 1:48 PM