User's Manual
Table Of Contents
- COMPUTER SOFTWARE COPYRIGHTS
- Notational Conventions
- Welcome
- What is the HC700-L Handheld Computer?
- Unpacking
- HC700-L Features
- Charging the Battery
- Figure 3. HC700-L Personal Desktop Cradle
- Battery Replacement
- Figure 4. Battery Replacement
- 1. Hold down the Power Button for at least four seconds until the HC700-L screen turns off.
- 2. Remove the HC700-L hand-strap (see Figure 4).
- 3. Press the battery snap on the battery (see Figure 4) and pull away the battery from the HC700-L.
- 4. Insert a fresh battery, bottom end first, into the battery compartment.
- 5. Carefully, press the battery top downward until it clicks and locks in place.
- 6. Press the Power Button - the HC700-L is now ready for use.
- First Time Battery Charge
- Routine Battery Charge
- Battery Maintenance
- Battery Disposal
- To Prevent Injury or Burns
- Using the HC700-L
- Starting to Work
- Turning On
- Turning Off
- Suspend Mode
- The Status LED
- The Application LED
- Using the Keypad
- Direct Action Keys
- Scanning Barcodes and Capturing Images
- Figure 8. Capturing Images with the HC700-L Imager
- 1. Run the Bcr barcode reader application: Start Menu- >Programs->Sample Applications->Bcr.
- 2. Aim and hold the HC700-L at 2 to 12 inches (5 to 30 cm) distance from the target.
- 3. Press one of the Scan keys and aim the green aiming bar towards the target to adjust your posi...
- Resetting the HC700-L
- Mini SD Memory Card
- Service
- ActiveSync (USB) Connectivity
- Troubleshooting
25
HC700-L
does not
respond
Problem in the
HC700-L oper-
ating system or
communica-
tions network
Ensure proper battery
installation in HC700-L.
Charge or replace the bat-
tery
Execute Warm Reset
“Resetting the HC700-L” on
page 20. The HC700-L
should function again
If HC700-L still does not
respond, perform Cold
Reset (see “Resetting the
HC700-L” on page 20). The
operating system will
reboot in 30 seconds
HC700-L ran-
domly
shuts off
Unclean bat-
tery contacts.
Clean the battery contacts,
see “Cleaning” on page 22.
Incomplete
or no data
transmission
between
HC700-L and
HC700-L Cra-
dle
HC700-L is not
docked prop-
erly in the cra-
dle
Make sure that the HC700-
L is properly docked in the
cradle
IrDA communi-
cation window
is obscured
Make sure that the IrDA
window of the HC700-L is
clean and has a clear line
of sight with the IrDA win-
dow of the cradle
Communica-
tion software
was incorrectly
installed or
configured
Refer to the HC700-L Cradle
user manual or see your
system administrator
Table 4: Troubleshooting the HC700-L
Problem Cause Solution
Enhanced IMD Users.book Page 25 Monday, October 23, 2006 1:48 PM