User's Manual

Battery Replacement

When the battery’s capacity is critically low, the HC700-G

automatically enters "Critical Low Battery" state and shuts

down all functions (the screen turns off) to preserve the data

in its memory. The HC700-G allows you to replace batteries

without losing information stored in its memory. To avoid los-

ing data stored in the memory, a charged battery must be

installed within 30 minutes.

To replace a battery perform the following steps:

1. Make sure that the HC700-G is powered off (See “Turn-

ing Off” on page 10.).

2. Remove the HC700-G hand-strap (see Figure 18).

3. Press the battery snap

on the battery (see Figure 18) and

pull away the battery from the HC700-G.

4. Insert a fresh battery, bottom end first, into the battery

compartment.

5. Carefully, press the battery top downward until it clicks

and locks in place.

6. Press the Power Button - the HC700-G is now ready for

use.

Figure 18. Battery Installation and Removal

Hand-strap

Battery Snap

Battery Compartment