User's Manual

Installing a microSD or CRYPTR micro Encryption Card
The LEX L10ig card holder can support either a microSD card or a CRYPTR micro encryption card.
The microSD card is a removable flash memory used for storing media on the LEX L10ig. The LEX
L10ig can support microSD cards with up to 64GB memory space. The CRYPTR micro encryption card
is used for voice encryption in features such as data and phone over Virtual Private Network (VPN)
and Push-to-Talk (PTT) communication. The CRYPTR micro provides FIPS 140-2 Level 3 storage for
credentials/keys for Data At Rest (DAR) encryption and MVPN. The slot of the card is located under
the LEX L10ig battery
When and where to use:
NOTICE: The LEX L10ig may be delivered to you with battery, SIM card, and microSD or
CRYPTR card already installed, activated, and ready for use. In case a CRYPTR is pre-
installed in the LEX L10ig, you must change the CRYPTR password provided by your technical
support. This is not a password to access the device but a password to protect Motorola
Solutions secure applications. The CRYPTR password is required whenever the LEX L10ig is
restarted.
Procedure:
1 Slide the card into the card holder slot with contacts facing down.
2 Push the card into the slot until it is fully seated and locked into place.
Figure 5: Installing the microSD or CRYPTR micro Encryption Card
Removing the microSD or CRYPTR Card
This procedure explains how to remove a microSD or CRYPTR micro encryption card.
Procedure:
1 Press and hold the Power button for three seconds.
2 Touch Power Off.
3 Touch OK.
4 Lift the battery cover.
5 Push the Card Holder lock down to release the card.
6 Remove the card from the holder.
7 Replace the battery cover.
MN002859A01-A
Chapter 2: Getting Started
Send Feedback 37