User's Manual

Item Function
Earpiece Provides audio in handset mode.
External Charging Contacts Provides power to the device from cradles.
Battery Cover Removal Slot Assists in battery cover removal to provide ac-
cess to the battery, SIM, CRYPTR, and mi-
croSD card holders.
microUSB Port Provides USB client and host communications.
Rear Camera and Flash Takes photos and video, and provides flash illu-
mination for the camera.
Unpacking
Carefully remove all protective material from the LEX L10i and save the shipping container for later
storage and shipping.
Verify that the following were received:
• LEX L10i
• Battery Cover
• 2280 mAh Lithium-ion battery
• Charger
• USB Cable
• Regulatory Guide
• Quick Start Guide
Inspect the equipment for damage. If any equipment is missing or damaged, contact the Motorola
Solutions Support Center immediately.
Setting Up the LEX L10i
The initial setup of the LEX L10i requires that the battery and any cards be installed.
NOTICE: The device may be delivered to you with battery, SIM card, microSD card and/or
CRYPTR cards already installed, activated, and ready for use. In this case, ignore steps 2
through 6 of the following section if they were already performed.
Before using the LEX L10i for the first time, perform the following:
1 Remove the screen protection film from the LEX L10i screen. (See Removing the Screen Protective
Film on page 34).
2 Install the public and/or Private SIM cards. (See Installing the Public and Private SIM Cards on
page 36).
3 Install the microSD or CRYPTR card (optional). (See Installing a microSD or CRYPTR micro
Encryption Card on page 35).
4 Install the battery. (See Installing the Battery on page 37).
5 Install the battery cover.
6 Charge the LEX L10i. (See Charging the LEX L10i on page 37).
MN002347A01-A
Chapter 2: Getting Started
Send Feedback 33