Installation Instructions

available CAN cable lengths. Control head ground, power and ignition sense wires (black, red, and

yellow respectively) may need more length (not supplied) in installations that locate the head more

than 10 feet from a power source.

Table 8: Available CAN Cables

Part Number Description

HKN6164_ Cable, Remote Mount, 40 m (131 ft)

HKN6165_ Cable, Remote Mount, 35 m (115 ft)

HKN6166_ Cable, Remote Mount, 23 m (75 ft)

HKN6167_ Cable, Remote Mount, 15 m (50 ft)

HKN6168_ Cable, Remote Mount, 9 m (30 ft)

HKN6169_ Cable, Remote Mount, 5 m (17 ft)

HKN6170_ Cable, Remote Mount, 3 m (10 ft)

PMLN4958_ Cable, O3 Extension, 5 m (17 ft)

Table 9: Ignition Interface Cables

Part Number Description

HLN6863_ Cable, M.A.P. 26 pin with Only Ignition and SPK

PMLN4959_ Cable, Y-Splitter with DB-25 and M.A.P. Interface

2.2.2.3

Cable Installation

Route the cables where they are protected from pinching, sharp edges or crushing. Use grommets in

any holes where the cable passes through metal panels.

Figure 41: Cabling Interconnect Diagram for Dash Mount on page 42 shows how the cables and

components are connected. It is not recommended to route cabling or wiring inside the wheel wells of a

vehicle.

2.2.2.4

Setting the Initial Control Head ID

The Front Panel Programming (FPP) mode allows you to define which control head in a Multi-Control

Head system becomes control head number 1–4.

Prerequisites: Set the control head ID number for each attached head the first-time Multi-Control

Head is used.

Procedure:

1 Press the Power button to power off the radio.

2 Simultaneously press and hold the left-most Soft Menu key and the Emergency button on the

control head.

MN005720A01-AB

Chapter 2: Standard Configurations