Installation Instructions

Mid Pow-
er Dash/
Remote
Transceiv-
er Red
Power
Wire
HLN6863
Thin Red
Wire at J2
Transceiv-
er Red
Power
Wire
HLN6863
Thin Red
Wire at J2
Transceiv-
er Red
Power
Wire
HLN6863
Thin Red
Wire at J2
High-Pow-
er Dash/
Remote
HLN6863
Thin Red
Wire at
J626
HLN6863
Thin Red
Wire at
J626
HLN6863
Thin Red
Wire at
J626
Connected
to ignition
switch
X X X
Ignition
switch
controls
No ignition switch control. Enables ignition switch
functionality as program-
med in the codeplug.
Illegal wiring configura-
tion.
CAUTION:
DO NOT connect any wires to the battery terminals until you have finished the entire radio
installation (dash or remote mount configuration) to avoid potential equipment damage.
Incorrect wiring of the radio may result in incorrect ignition sense detection, incorrect power-on
state, or incorrect power-off state of the radio system.
The Control Head Power cable wire (RED) and Transceiver Power cable wire (RED) are always
attached to the battery terminal and NOT to the ignition switch.
2.1.4
Ignition Sense Switch (Radio Wide Advance)
The CPS (Customer Programming Software) selectable settings is used to control the radio
functionality based on the state of the vehicle Ignition status. These descriptions can be found in the
CPS tool HELP Guides and are repeated here for convenience.
Table 5: Ignition Sense Switch Settings in CPS
Feature Description
Blank
• Radio POWERS ON when the Power button is pressed or with the Emer-
gency Power-up feature.
• Radio POWERS OFF when the Power button is pressed.
TX Inhibit
• Radio POWERS ON when the Power button is pressed or with the Emer-
gency Power-up feature.
• Radio POWERS OFF when the Power button is pressed.
• If IGNITION is not present, all transmissions are inhibited.
• The radio does not affiliate with trunking systems and therefore cannot
receive any trunking dispatch communications.
• Emergency Alarm transmissions are NOT possible with the use of the
Emergency Power-up feature.
PTT TX Inhibit
• Radio POWERS ON when the Power button is pressed or with the Emer-
gency Power-up feature.
• Radio POWERS OFF when the Power button is pressed.
MN005720A01-AB
Chapter 2: Standard Configurations
47